Valcom V-1030M, V-1048M, V-1036M Service Manual
VSP-V-1030M/1036M/1048M
Issue 6
MARINE HORNS
V-1030M - 5 WATT PAGING HORN AMPLIFIER ASSEMBLY
V-1036M - 15 WATT PAGING HORN AMPLIFIER ASSEMBLY
V-1048M - 45 OHM TALKBACK HORN
INTRODUCTION
This instruction contains the specifications and
information necessary to install, operate and maintain
the V-1030M and V-1036M Paging Horn Assemblies
and the V-1048M 45 Ohm Talkback Horn.
This equipment has received FCC type KX registration,
designed to be used with FCC registered Key
Telephone Systems. In accordance with FCC Rules
with applicable tariffs, this Paging Unit may be
installed with the authorization of the host system.
Installations may be made by Valcom, Inc., an
authorized agent of the same, equipment
manufacturers, telephone companies, registered
telephone refurbishers, and those qualified for
installation of FCC registered systems under FCC
Rules Section 68.215.
The FCC Registration Number, BAF9I7-69358-KX-N,
will be listed in the affidavits filed with the telephone
company; it will also be recorded in the system log kept
by installation and maintenance personnel. The local
telephone company is to be notified of the FCC
Registration Number when this Paging Unit is
installed.
DESIGN
These horns are designed for marine use and can be
used for interior or exterior paging applications. They
are enclosed in a white, no fade, high impact, sealed
plastic housing. They are fully adjustable 360 degrees
horizontal and 90 degrees vertical. They are supplied
with stainless steel hardware and a beam mount clamp.
Environment
• Temperature: -20 to +55°C
• Humidity: 0 - 95% (non-precipitating)
Dimensions/Weight
• V-1030M/V-1036M
7.38"H x 10.00"W x 10.40"D
(18.75cm x 25.40cm x 26.42cm)
3.7 lbs. (1.68kg)
• V-1048M
7.38"H x 10.00"W x 10.40"D
(18.75cm x 25.40cm x 26.42cm)
3.5 lbs. (1.59kg)
SPECIFICATIONS/
CONNECTIONS FOR THE
V-1030M/V-1036M
The V-1030M and V-1036M are Paging Horn/
Amplifier Assemblies. The V-1030M is a selfcontained 5 Watt paging system with a 5 Watt
amplifier; the V-1036M is a self-contained 15 Watt
paging system with a 15 Watt amplifier. Both units
incorporate a high efficiency horn with a volume
control.
1 947032
Applications of the V-1030M and
V-1036M
• Use with Valcom page control
• Expanding the capability of telephone systems
which contain limited paging capabilities
• Loud ringer application in systems where
loud-speaker tone signaling is employed.
V-1030M - Nominal Specifications
Input Impedance: 600 Ohm nominal
Input level: -15dBm to +10dBm
Current at -24VDC: 300mA
V-1036M - Nominal Specifications
Input Impedance: 600 Ohm nominal
Input level: -15dBm to +10dBm
Current at -24VDC: 900mA
Horn Spacing for the
V-1030M/V-1036M
(coverage shown in parenthesis)
Location
Quiet
Moderate
Noisy
Very Noisy
Example: In a quiet environment, V-1030M 5 Watt
horns would be spaced 110 feet apart side to side and
would provide good quality sound 110 feet in front of
each horn approximately 12,000 sq. ft. of coverage.
Definitions:
Quiet: 50-65dB. This would include stock areas, etc.
Moderate: 65-80dB. This includes areas such as
warehouses, shipping areas or light manufacturing.
Noisy: 80-90dB. This includes machine shops or
heavy manufacturing.
Very Noisy: Greater than 90dB. This would include
any areas where talking to another person is very
difficult. Workers may be required to wear earplugs.
V-1030M
5 Watt
110'
(12,000 sq. ft.)
80'
(6,400 sq. ft.)
50'
(2,500 sq. ft.)
30'
(900 sq. ft.)
V-1036M
15 Watt
N/A
N/A
75'
(5,600 sq. ft.)
45'
(2,000 sq. ft.)
Audio Wire Runs (V-1030M/V-1036M)
When a remote power unit is used, the audio pair run
should be limited to 5000 feet and a maximum of 4
horns when using 24AWG wire. A V-1094A may be
added to increase the number of horns and/or distance.
Twisted pair wire (standard telephone wire) should be
used for connections.
Power Wire Run (V-1030M/V-1036M)
For good quality sound, the distance recommended
between the power supply and horns should be adhered
to.
Number of Horns
per Power Run
15 Watt 5 Watt
V-1036M V-1030M 24AWG 22AWG
1 4 125 200
0 2 250 400
0 1 500 800
Wire Run Length
(feet)
See the Valcom power run gauge guide for additional
wire gauges and distances.
Wiring Connections
(V-1030M/V-1036M)
Twisted pair wire (standard telephone wire) should be
used for connections.
Audio In
Green - Tip
Red - Ring
Power In
Black - Ground
White - (-24VDC)
Brown - Not Used
SPECIFICATIONS/
CONNECTIONS FOR THE
V-1048M
Application
The V-1048M talkback horn is designed to be used
with "handsfree" talkback control units. In combination
with these units, the speaker provides both loudspeaker
and talkback functions.
A standard talkback paging system is comprised of
three basic components:
1. Talkback page control unit
2. Speakers
3. Power Supply
2
Loading...