Valcom V-1022C-27C, VSP-V-1016 User Manual
VSP-V-1016,V-1022C-27C
INSTALLATION INSTRUCTIONS FOR
ONE-WAY AMPLIFIED INTERIOR WALL SPEAKERS
Issue 4
V-1016-B, V-1016-W
V-1022C, V-1024C, V-1026C
Valcom One-Way Amplified Interior Speakers,
V-1016-W, V-1016-BK, V-1022C, V-1023C,
V-1024C, V-1025C, V-1026C, V-1026C-W,
V-1027C, are self-amplified and capable of
reproduc ing paging as well as bac kground music.
These speakers have externally accessible volume
controls that are screwdriver adjustable. The
enclosures are vinyl laminated pressboard with either
a coordinating cloth or woven can grille. All
speakers require -24 Vdc, 50 mA (1 power unit) and
are FCC Part 68 registered under
BAFUSA-69358-KX-N.
INSTALLATION
Page
Out
Valcom Page
Control
Typical Connections
(Tip/A)
(Ring/B)
(-24Vdc)
(Gnd)
One-Way
Amplified
Speaker
Valcom -24 Vdc
Power Supply
V-1023C, V-1025C, V-1027C
Mounting
Ideal mounting heights are 8 to 12 ft. above the floor.
V-1016-BK, V-1016-W, V-1022C, V-1023C:
Remove the screw holding t he mounting bracket to
the speaker housi ng. Mount bracke t using appropriate hardware such as #8 pan head screws. After
making the required connections, reattach the speaker
housing to the mounting bracket.
• V-1016 – 9.7”H x 11.5”W x 4.0”D
(24.6cm H x 29.2cm W x 10.16cm D)
• 4.1 lbs. (1.86kg)
• V-1022C – 9.6”H x 11.5”W x 4.2”D
(24.4cm H x 29.2cm W x 10.7cm D)
• 4.5 lbs. (2.04kg)
• V-1023C – 9.6”H x 11.5”W x 4.2”D
(24.4cm H x 29.2cm W x 10.7cm D)
• 4.1 lbs. (1.86kg)
V-1024C, V-1025C: After making required c onnections, use appropriate hardware such as an 8d
finishing nail to hang the speaker housing in the
corner.
• 10.5”H x 9.5”W x 6.3”D
(26.7cm H x 24.1cm W x 16cm D)
• 3.6 lbs. (1.63kg)
NOTE: Do not connect this speaker directly to a
25/70/100 volt amplifier as damage to both the
amplifier and speaker may occur. A V-1095 may
be used to allow the use of Valcom self-amplified
speakers on 70V speaker lines.
1 947296
V-1026C, V-1026C-W, V-1027C: Remove wing
nuts holding mounting bracket to speake r housing.
Remove bracket a nd mount using appropriate
hardware such as #8 pan head screws. Reattach
speaker housing to mounting bracket. Remove the 4
screws holding the reverse side grille to the speaker
housing and remove the grille. After making required
connections, reattach the grille to the speaker
housing.
• 10.3”H x 10.3”W x 4.2”D
(26.2cm H x 26.2cm W x 10.7cm D)
• 5.6 lbs. (2.54kg)
COVERAGE
The area covered by a wall speaker is typically 600
square feet.
Number of Speakers per Audio Run
Wire Run (Ft.) 22 AWG 24 AWG
400
800
1600
100
50
25
60
30
15
Number of Speakers per Power Run
1 Watt Interior
Speakers 22 AWG
30
15
7
200 ft.
400 ft.
800 ft.
24 AWG
125 ft.
250 ft.
500 ft.
TECHNICAL ASSISTANCE
When trouble is reported, verify there are no broken
connections. Assistance in troubleshooting is
available from the factory. Call (540) 427-3900 and
ask for Technical Support, or call (540) 427-6000 for
Valcom 24-hour Automated Support or visit our
website at http ://www.valcom.com.
Valcom equipment is not field repairable. Valcom,
Inc. maintains service facilities in Roanoke, VA.
Should repairs be necessary, attach a tag to the unit
clearly stating company name, address, phone
number, contact person, and nature of the problem.
Send the unit to:
Valcom, Inc.
Repair & Return Dept.
5614 Hollins Road
Roanoke, VA 24019-5056
SYMPTOM ACTION
1. No audio from
speaker.
2. Low volume from
speaker.
3. Loud squeal
(feedback).
TROUBLESHOOTING CHART
1a. Check that volume control is turned up (clockwise).
1b. Using a lineman's test set check for the proper audio level on the Tip and Ring
leads, and if necessary also at the source.
2a. Check that volume control is turned up.
2b. Check voltage at the speaker assembly when in use, -18 to -24 Vdc required.
2c. Using a lineman's test set, check for the proper audio level on Tip and Ring
leads. It is possible that some low level audio will be heard with only one side of
Tip and Ring connected.
3a. Turn down (counter-clockwise) volume of the speaker .
3b. Increase the distance between the telephone and speaker.
3c. Install a noise canceling handset on the telephone in severe problem areas.
3d. Add a V-9962 Digital Feedback Eliminator.
2 947296
Loading...