Valcom V-1010C, V-1020C Service Manual

VSP-1010C/1020C/1020KNOB/1021C

INSTALLATION INSTRUCTIONS FOR

AMPLIFIED CEILING SPEAKERS

Issue 6

V-1010C

Valcom Ceiling Speakers, V-1010C, V-1020C, V-1020KNOB and V-1021C are self-amplified and are capable of reproducing voice paging as well as background music. The V-1020KNOB has a permanent knob for volume adjustments, the V-1010C and V-1020C feature a removable volume control knob and the V-1021C has an externally accessible volume control that can be adjusted by screwdriver through the center hole on the grille. The V-1010C is a 4-inch speaker and the others are 8-inch speakers. All speakers require -24VDC, 50mA (1-power unit) and are FCC Part 68 registered under BAFUSA-69358-KX-N.

Volume Control

V-1020C/V-1020KNOB

(Knob included with V-1010C and V-1020C)

V-1021C

Dimensions/Weight

• V-1010C 7.65"Dia. x 2.90"D (19.43cm Dia. x 7.37cm D) 1.7 lbs. (0.77kg)

• V-1020C/1020KNOB 13.00"Dia. x 3.00"D (33.02cm Dia. x 7.62cm D) 2.5 lbs. (1.13kg)

• V-1021C 11.00"Dia. x 3.00"D (27.94cm Dia x 7.62cm D) 1.5 lbs. (0.68kg)

1 947295

Page

Out

Valcom Page Control

(Tip/A)

(Ring/B)

(-24VDC)

(Gnd)

FIGURE 1: TYPICAL CONNECTIONS

FIGURE 2: V-1010C INSTALLATION INSTRUCTIONS

One-Way

mplified

Speaker

Valcom -24VDC Power Supply

NOTE: Do not connect this speaker directly to a 25/70/100 Volt amplifier as damage to both the amplifier and speaker may occur. A V-1095 may be used to allow the use of Valcom self-amplified speakers on 70V speaker lines.

V-9915M-5 Backbox

Bend tabs down to locate bridge in ceiling tile cutout.

he V-9904M-5 is recommended

or use where extra speaker support is needed. A V-9915M-5 may be added to the V-9904M-5

or backbox protection

NOTE: The V-9915M-5 cannot be used in V-1010C installations

ithout the V-9904M-5.

V-9904M-5 Bridge

ttach backbox t bridge us ing 4 screws provided

Cut 5.25" round hole in ceiling tile

4" Ceiling Grille and Speaker

2 947295

+ 2 hidden pages