Valcom IP Solutions VIP-160 User Manual

Issue 1

Issue 2

VIP-160

TALKBACK IP CEILING SPEAKER

INTRODUCTION

The VIP-160 Talkback IP Ceiling Speaker enables
handsfree talkback access to a single location over
an IP-based LAN/WAN. This allows handsfree
communication anywhere on the network. The
VIP-160 levels are adjusted electrically via software
during setup. A call switch input is provided for call
in initiation. Power is provided to the VIP-160 via a
Power over Ethernet (PoE) switch meeting the

802.3af specification.

SPECIFICATIONS

Access Methods

 PBX, FXO Port w/VIP-811
 POTS telephone set w/VIP-811
 PBX, FXS Port w/VIP-821
 Valcom M Cast Page Group
 SIP – enabled telephone system

Features

 RJ-45 network connection
 802.3af compliant
 High Efficiency Class-D Amplifier

INSTALLATION

FCC Information

This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment is
operated in a commercial environment. This
equipment generates, uses and can radiate radio
frequency energy and if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area
may cause harmful interference in which case the
user will be required to correct the interference at
his own expense.

Packing List

Qty. Item

1 VIP-160
1 VSP Document

1 947792

DIMENSIONS/WEIGHT

 13.00” Dia x 3.00” D
(33.02cm Dia. x 7.62cm D)
 Weight: 2.5 lbs (1.13 kg)

Environment

Temperature: 0 to +40° C
Humidity: 0 to 85% non-precipitating

Precautionary Designations

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: To reduce the risk of electric shock,
Refer se rvic ing to qu alifie d serv ice pers onn e l.

Do not remove cover.

No user serviceable parts inside.

This symbol indicates that dangerous
voltage constituting a risk of electric
sho ck is pre s ent within this un it.

This symb o l indica tes that there are
imp o rtant op er ating a nd m a inte nance
instruction s in the lit erature accompanyin g

this unit.

Network Connection

The VIP-160 has one RJ-45 network connector on
the rear panel. Connect the VIP-160 to an Ethernet
switch. (See Figure 1).

Call Switch Connection

The Talkback IP Speaker provides a call switch
input via screw terminal connections. See
Figure 1 for detailed connections.

Mute Out Connection: The Mute Out may

optionally be connected to the mute input of

Valcom Classroom audio management systems in
order to suspend locally originated classroom audio
during intercom announcements.

LED (+) and (-) Connection: LED (+) and

(-) is a current limited output designed to illuminate
an optional LED. The LED is intended to provide
visual indication of call progress. The LED
illumination will flash when the call switch is
pressed and will continue to flash until the call is
answered. The LED illumination will be solid while
a connection to the IP Talkback Speaker is
established.

-10 dB Line Level Out Connection: the

-10dBm Line Level Out may be connected to up to
40 Valcom Self Amplified Speakers in order to
provide additional sound reinforcement in an area.

Figure 1. VIP-160 Connections

Setup

Information specific to your application will need
to be programmed into the VIP-160 using a
computer. The PC used for programming should
be connected to the same subnet as the VIP-160.
Setup will be done using the IP Solutions Setup
Tool. Download the latest versio n of the free IP
Solutions Setup Tool from Valcom web site at
www.valcom.com/vipsetuptool.

MOUNTING

Cut an 8.50” diameter in ceiling tile. After
connections have been made to the speaker, attach
speaker to ceiling tile using the mounting hardware
provided. (A metal backbox with rails is available
separately as model V-9816M).

TECHNICAL ASSISTANCE

When trouble is reported, verify power is being
supplied to the unit and there are no broken
connections. If a spare unit is available, substitute
a spare unit for the suspected defective unit.

Assistance in troubleshooting is available from the
factory. Call [phone] and press 1 for
Technical Support or via email at
[e-mail]

When requesting assistance, you should include all
available information. It is strongly suggested that
you go to the web site and review the information at
www.valcom.com.

Valcom equipment is not field repairable. Valcom,
Inc. maintains service facilities in Roanoke, VA.
Should repairs be necessary, attach a tag to the
unit clearly stating your company name, address,
phone number, contact person and the nature of
the problem. Send the unit to:

Valcom, Inc.

Repair & Return Dept.

5614 Hollins Road

Roanoke, Va. 24019-5056

2 947792

Valcom, Inc. warrants its products only to the original purchaser, for its own use, to be free from defects in materials and workmanship under conditions of
normal use and service for a period of one year from the date of shipment. This Limited Warranty obligation shall be limited to the replacement, repair or
refund of any such defective device within the warranty period, provided that:

1. inspection by Valcom, Inc. indicates the validity of the claim;

2. the defect is not the result of damage, misuse or negligence after the original shipment;

3. the product has not been altered in any way or repaired by others and that factory sealed units are unopened (a service charge plus parts
and labor will be applied to units defaced or physically damaged);

4. freight charges for the return of products to Valcom are prepaid;

5. all units 'out of warranty' are subject to a service charge. The service charge will cover minor repairs (major repairs will be subject to
additional charges for parts and labor).

This Limited Warranty is in lieu of and excludes all other warranties, expressed or implied and in no event shall Valcom, Inc. be liable for any
anticipated profits, consequential damages, loss of time or other losses incurred by the buyer in connection with the purchase, operation,
maintenance, installation, removal or use of the product. The maximum liability of Valcom under this warranty is limited to the purchase price of the
specific Product covered by the warranty.

Disclaimer. Except for the Limited Warranty provided herein, the product is provided “as-is” without any warranty of any kind whatsoever including, without

limitation, any WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NON-INFRINGEMENT.
This warranty specifically excludes damage incurred in shipment. In the event a product is received in damaged condition, the carrier should be notified

immediately. Claims for such damage should be filed with the carrier involved in accordance with the F.O.B. point.

VALCOM LIMITED WARRANTY

Headquarters:

Valcom, Inc.

5614 Hollins Road Roanoke, VA 24019-5056

Phone: [phone] FAX: [phone]

3 947792