DOUBLETAKE
Tandem Stroller
PRODUCT REFERENCE GUIDE
Thank you for purchasing a quality VEE BEE product.
Please read and follow the instructions outlined in this
guide carefully. Familiarise yourself with the construction
and safety features; be sure that you understand all the
warnings and safety guidelines before use.
Important: Please read the following instructions
carefully before assembling this product. Retain this
guide in a safe place for future reference.
DISCLAIMER
Due to our policy of continuous product development,
this product is constantly evolving. It is possible that
some features or procedures outlined here have
changed since this document was written. If you are
unsure of any procedure shown here, please contact us
via the web at info@valco.com.au to obtain the most
up to date information before use. Include the batch
number, which can be found on a sticker on the frame.
All pictures and diagrams herein are provided for
illustration purposes only. Actual product, colour or
fabric may vary. VALCO BABY reserves the right to modify
or alter any specication or colour without notice or
obligation to modify any product previously purchased
by valco baby
A>UNFOLD
FURTHER INFORMATION
In Australia/New Zealand
www.veebee.com.au
© Copyright VB 2017
vs300117
VEEBEE DoubleTakeIM_020818.indd 1 2/8/18 3:27 pm
Find us on:
FURTHER INFORMATION
In Australia/New Zealand
www.veebee.com.au
PAGE 1
B>FRONT WHEELS
IMPORTANT WARNING ! ALWAYS TEST THAT WHEELS ARE
FULLY ENGAGED BY PULLING ON EACH FIRMLY AWAY
FROM THE AXLE/FIXTURE.
CLICK
C>REAR WHEELS
E>FRONT TRAY
D>FOOTREST
SNAP ON
PUSH
DOWN
F>HOOD
PAGE 2
VEEBEE DoubleTakeIM_020818.indd 2 2/8/18 3:27 pm
FOLD
G>FOLD
BUTTON
RELEASE
BUTTON
H>SEAT ADJUSTMENT
I>OPEN
J>BRAKES
INDEPENDENT BRAKE MODEL
TO ENGAGE THE BRAKE, DEPRESS EACH BRAKE
PEDAL INDEPENDENTLY. ALWAYS DEPRESS BOTH
BRAKES WHEN STROLLER IS STOPPED
JOINT BRAKE MODEL
DEPRESS BRAKE BAR TO SIMULTANEOUSLY
ENGAGE WHEEL BRAKES. ALWAYS ENGAGE
BRAKES WHEN STROLLER IS STOPPED
PAGE 3
VEEBEE DoubleTakeIM_020818.indd 3 2/8/18 3:27 pm
K>TETHER STRAP
WARNING: USE THIS
STRAP TO STOP THE
PRAM/STROLLER
ROLLING AWAY
L>HARNESS
a
‘CLICK’
d
e
Cb
‘PRESS’
PAGE 4
VEEBEE DoubleTakeIM_020818.indd 4 2/8/18 3:27 pm
INSTRUCTIONS
Remove the stroller from the carton. The
front wheels, rear wheels, child’s tray,
footrest and front canopy all need to be
installed prior to use.
A>UNFOLD YOUR STROLLER:
1. Lean the stroller so that the handlle and
rear frame tubes are resting on the floor
and the front wheel tubes are pointing
upward.
B>ATTACHING THE FRONT WHEELS
2. Position the front wheel assemblies so
that the large hole will slide over the front
leg tubes.
3. Push down on each assembly so that it
locks into place on each front tube.
IMPORTANT WARNING: PULL FIRMLY
ON EACH WHEEL AND TEST THAT IT
IS LOCKED SECURELY IN PLACE.
C>ATTACHING THE REAR WHEELS
4. Lean you stroller forward to rest on the
front wheels.
5. Install the rear wheel assembly,
positioning it so that the brake levers are
facing away from the stroller.
6. Place the wheel housings over the
wheel tubes. Press each of the spring
loaded buttons in turn and simultaneously
push the corresponding housing up over
the tube until it locks into place.
IMPORTANT WARNING: PULL FIRMLY
ON THE REAR ASSEMBLY AND TEST
THAT IT IS LOCKED SECURELY IN PLACE.
D>ATTACHING THE FOOTREST
7. Snap the footrest onto each of the front
legs just below the seat.
8. Push downward on the footrest until it
snaps onto the “U” shaped frame cross
member.
E>INSTALLING THE FRONT TRAY
9. Line up and insert the side channels in
the tray with the front leg tubes and insert.
10. Swing the latch on either side around
the tube and lock into place.
11. To remove the tray simply reverse this
procedure.
IMPORTANT WARNINGS:
THE FRONT CHILD TRAY IS NOT A
RESTRAINT DEVICE. ALWAYS SECURE
YOUR CHILD WITH THE HARNESS
RESTRAINT SYSTEMS PROVIDED.
DO NOT LIFT THE STROLLER BY THE
FRONT CHILD TRAY. ALWAYS USE CARE
WHEN ATTACHING THE FRONT TRAY
WITH A CHILD IN THE STROLLER.
F>INSTALLING THE FRONT HOOD:
12. Line up the square male fittings of
the canopy with the female fittings in the
armrest housing.
13. Push each fitting downward until each
snaps into place.
G>FOLDING YOUR STROLLER: Close
the canopies:
14. Pull the rear canopy back up aginst the
handle.
15. Fold the front canopy backward until it
is flat to the stroller body.
16. Press the release button in the
centre of the handle while simultaneously
squeezing the fold button in the centre
of the handle. While holding these two
buttons, depress the foot pedal found
on the left side of the stroller.The stroller
should then begin to fold.
17. Release the handle and pull up on the
front tray until the stroller is fully folded.
18. Secure the stroller in the folded position
by swinging the fold latch, located on the
right side of the stroller handle, over the
extended rivet head on the armrest.
H>SEAT ADJUSTMENT:
19. The front seat can be reclined to 2
positions. Lift the trigger bar in the rear
of the front seat and move the seat to the
required position.
20. The rear seat can be reclined to a
multitude of positions. This is controlled
by the strap and buckle assembly located
behind the rear seat. To recline, loosen the
strap through the buckle and adjust to the
required position. The seat will then drop
to the appropriate position.
21. To lift the seat to a more upright
PAGE 5
VEEBEE DoubleTakeIM_020818.indd 5 2/8/18 3:27 pm
INSTRUCTIONS
position, lift the seat back upward with one
hand while pulling the straps outward with
the other. The straps should lock in place
automatically.
IMPORTANT WARNING: THE FULLY
UPRIGHT POSITIONS SHOULD ONLY
BE USED FOR A CHILD THAT IS AT LEAST
SIX MONTHS OF AGE.
I>TO OPEN YOUR STROLLER:
22. Release the folding latch.
23. Standing behind the stroller, lift up the
stroller handle with both hands until the
frame is fully errect and locked into the
open position.
IMPORTANT WARNING: ALWAYS
TEST THAT THE FRAME IS FULLY
LOCKED PRIOR TO PLACING YOUR
CHILD(REN) IN THE STROLLER.
J>USING YOUR BRAKES:
23. To lock, simply press down on the the
brake lever until each individual brake’s
pins engage into the corresponding wheel
cog. The stroller may require a slight
forward or rearward movement in order to
line up the brake pins in the cogs.
24. To unlock, release the brake pin from
the wheel cogs by lifting the brake lever.
IMPORTANT WARNING: ALWAYS
CHECK THAT THE BRAKES HAVE
ENGAGED IN THE WHEEL COGS BY
TESTING THAT THE WHEELS CANNOT
ROTATE. ALWAYS SET THE BRAKES
WHEN THE STROLLER IS NOT IN MOTION
SO THAT IT WILL NOT ROLL AWAY. EXTRA
CAUTION IS REQUIRED WHEN ON AN
INCLINE OR HILL.
K>TETHER STRAP
WARNING: USE THIS STRAP TO STOP
THE PRAM/STROLLER ROLLING
AWAY.
L>HARNESS
Your stroller harness is specifically
designed with many built in safety features.
This includes the requirement that, when
opened, all straps are released so that no
dangerous loops can be formed causing a
strangulation hazard.
WARNING: YOUR CHILD MUST
ALWAYS BE HARNESSED WHEN IN
THE STROLLER
Closing your harness: Slide each of the
shoulder strap bottom guides (a) into the
corresponding channel on the top of each
side strap prong. Insert each completed
prong into the central buckle housing (b).
Carefully adjust the harness straps to snugly
fit your child by adjusting the sliders (c)
located on each strap. The harness should
be fitted to your child’s body, tight enough
so that they cannot wriggle free of the straps
but, loose enough, so as not to cause any
discomfort.
For even more flexibility, the height at
which your shoulder straps are fitted to the
stroller can be adjusted at 3 points(d).
To change the shoulder strap position:
Open the harness. Rethread the shoulder
strap strap back through the desired loop
on the front of the seat
Opening your harness: Press the central
housing button (e). This will release both
side prongs from the central housing.
The shoulder and waist straps will release
automatically from each other.
If the shoulder and waist straps do not
automatically disengage from each other,
manually slide the guides of the waist
channels. Your harness will separate into
5 sections.
IMPORTANT WARNING: WHEN NOT
IN USE, BE SURE THE SHOULDER
AND WAIST STRAPS ARE ALWAYS
DISCONNECTED FROM THE CENTRAL
HOUSING AND EACH OTHER
PAGE 6
VEEBEE DoubleTakeIM_020818.indd 6 2/8/18 3:27 pm
WARNING: TO AVOID INJURY OR DEATH
• FOLLOW THE MANUFACTURER’S INSTRUCTIONS.
• ALWAYS APPLY THE BRAKES WHENEVER THE PRAM/STROLLER* IS STATIONARY.
• DO NOT LEAVE CHILDREN UNATTENDED.
• DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS PRAM/STROLLER*.
• MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF YOU ADJUST THE PRAM/
WARNING
• WHEN NOT IN USE DISCONNECT SHOULDER STRAPS FROM THE WAIST STRAP AND/OR
BUCKLE.
REMEMBER, YOUR CHILD’S SAFETY IS YOUR RESPONSIBILITY...
• NEVER USE ON STAIRS OR ESCALATORS.
• ALWAYS USE THE TETHER STRAP WHEN THE STROLLER IS IN USE.
• THE CORRECT USE AND MAINTENANCE OF THIS VEHICLE ARE ESSENTIAL.
• BE SURE THAT ALL CLAMPS AND BUCKLES ARE SECURELY FIXED AND IN PLACE BEFORE USE
WARNING
•
THE MAXIMUM WEIGHT OF EACH CHILD FOR WHICH THIS STROLLER WAS INTENDED IS 18KGS (39LBS).
•
THE MAXIMUM HEIGHT OF EACH CHILD FOR WHICH THIS STROLLER WAS INTENDED IS 90CM (35INCHES).
• THE STROLLER MAY BECOME UNSTABLE IF THE MANUFACTURER’S RECOMMENDED LOAD IS
EXCEEDED.
• CARE MUST BE TAKEN WHEN FOLDING AND UNFOLDING THE PRODUCT TO PREVENT
FINGER ENTRAPMENT.
• NEVER RUN WITH A NEWBORN BABY IN ANY PRAM OR STROLLER UNTIL THE CHILD CAN SIT UP
UNASSISTED (APPROXIMATELY 6 MONTHS).
• CHECK ALL PARTS BEFORE USE FOR BREAKAGE OR FATIGUE. DISCONTINUE USE IMMEDIATELY
IF ANY PART IS FOUND TO BE DAMAGED OR BROKEN.
• MAXIMUM LOAD OF BASKETS: 3.5KGS (7.5LBS).
•
DO NOT CARRY ADDITIONAL CHILDREN. THIS STROLLER IS MANUFACTURED FOR USE WITH TWO
CHILDREN ONLY
• ALWAYS BE AWARE OF THE RISKS PROVIDED BY FIRE AND OTHER SIGNIFICANT SOURCES OF HEAT
SUCH AS RADIATORS, ETC. WHICH MAY BE IN THE IMMEDIATE VICINITY OF YOUR STROLLER.
• IT MAY BE UNSAFE TO USE ANY ACCESSORIES OTHER THAN VALCO BABY APPROVED ONES.
•
THIS PRODUCT IS INTENDED FOR DOMESTIC USE ONLY. IT IS NOT INTENDED FOR COMMERCIAL USE.
• THIS STROLLER IS DESIGNED FOR USE ON FLAT OR GENTLY SLOPING SURFACES AND MAY
BECOME UNSTABLE OR TIP OVER IF USED ON HIGH SLOPING OR UNEVEN SURFACES.
• ALWAYS ENGAGE THE FRAME LOCK WHEN FOLDED. TAKE CARE WHEN LIFTING THE VEHICLE TO
KEEP YOUR KNEES BENT AND BACK STRAIGHT. DO NOT CARRY THE VEHICLE BY THE HOOD OR THE
REAR BRAKE AXLE. ALWAYS USE THE CARRY HANDLE.
Should the chassis become wet, dry off pr omptly before storing. If this pram is used near the ocean or salted roads, spray the chassis and seat
frame with water and dry. We recommend a rust inhibiting product should be used to prevent rust and fatigue on metal par ts. We recommend
that you wipe down axles and lubricate the wheels every 3 months. Sand and dirt can grind down axles, if you live near the beach or in a dusty
environment you must wipe down the axles and wheels then lubricate them monthly.
AXLES ARE BEST LUBRICATED WITH GREASE OR PETROLEUM JELLY. MOVING PARTS ARE BEST LUBRICATED WITH SILICONE BASED PRODUCTS.
DO NOT USE OIL BASED PRODUCTS.
STROLLER*, OTHERWISE THEY MAY BE INJURED.
• SECURE THE CHILD IN THE HARNESS AT ALL TIMES.
•
USE THIS HARNESS AT ALL TIMES. ALWAYS USE THE HARNESS,
CORRECTLY FITTED AND ADJUSTED, WITH YOUR CHILD IN THIS SEAT.
PAGE 7
VEEBEE DoubleTakeIM_020818.indd 7 2/8/18 3:27 pm
FURTHER INFORMATION:
Find us on:
veebee.com.au
PAGE 8
VEEBEE DoubleTakeIM_020818.indd 8 2/8/18 3:27 pm
Loading...