Valco Baby Twin Tri-mode Toddler Seat User Manual
TWIN TODDLER SEAT
PRODUCT REFERENCE GUIDE
TWIN TODDLER SEAT
Thank you for purchasing a quality VALCO product. Please read and follow the instructions outlined in this
guide carefully. Familiarise yourself with the construction and safety features; be sure that you understand all
the warnings and safety guidelines before use.
Retain this guide in a safe place for future reference.
Important: Please read the following instructions carefully before assembling this product. Retain this guide in
a safe place for future reference.
Due to our policy of continuous product
development, this product is constantly
evolving. It is possible that some features or
procedures outlined here have changed since
this document was written.
If you are unsure of any procedure shown
here, please contact us via the web at
info@valco.com. au or
info@valcobaby.com in North America,
to obtain the most up to date information
before use. Include the batch number, which
can be found on a sticker on the frame.
© Copyright VE 2008
All pictures and diagrams herein are provided
for illustration purposes only. Actual product,
colour or fabric may vary. VALCO reserves the
right to modify or alter any specication or
colour without notice or obligation to modify
any product previously purchased
FURTHER INFORMATION
In Australia/New Zealand
www.valco.com.au
www.valco.co.nz
In North America only
www.valcobaby.com
1800 610 7850
TO INSTALL YOUR TWIN
Remove Bumper Bar or Plugs
Bumper Bar
Nylon Plug
press
1
A
TRI-MODE TODDLER SEAT:
(THE EASY WAY!)
FIGURE A
1. Before you begin to install the toddler
seat make sure to remove the bumper bar
or nylon plugs from the housing on the
1
stroller frame.
To do so: From the underside of the nylon
housing, feel the side of the nylon housing
that sits below the frame at each side of the
stroller (the place where the bumper bar
connects to the stroller).
B
2. Locate the center release “button.” (1)
3. Press the release button inward while
simultaneously pushing upward on the bar
or plug.
4. Repeat for the other side.
NOTE: TO AVOID FINGER ENTRAPMENTS,
THE NYLON PLUGS MUST BE
RETAINED AND INSTALLED WHEN THE
BUMPER BAR OR TODDLER SEAT IS NOT
IN USE.
FIGURE B
C
5. Remove the toddler seat from the box.
Your toddler seat will come folded at and
compact.
FIGURE C
6. Open the seat up by pulling the seat
back away from the ‘U’ shaped metal bar.
1
FIGURE D
CLICK
D
7. Locate the swivelling mini rod, located on
each side of the toddler seat.
FIGURE E
E
8. Simultaneously rotate both mini rods,
and the ‘U’ shaped metal bar, so that they
meet.
9. Insert the ‘U’ legs into the nylon housings
of the mini rods until you feel them click
into place.
NOTE: UNTIL YOU HEAR A CLICK, THE BAR
IS NOT SECURE.
FIGURE F
F
10. You Toddler Seat is now fully
assembled.
11.Insert the seat connectors into the
housings on either side of your stroller (the
place where the bumper bar goes).
12. Once secured, slightly lift up the toddler
seat to ENSURE each leg has fully engaged
in each housing.
2
Loading...