Valco baby Twin Latitude Car Seat Adapter Reference Manual

Thank you for purchasing a quality VALCO product. Please read and follow the instructions outlined in this
guide carefully. Familiarise yourself with the construction and safety features; be sure that you understand all
the warnings and safety guidelines before use. This product is for use with the VALCO Latitude stroller in North
American only. This product is not intended for use in Australia.

Important: Please read the following instructions carefully before assembling this product. Retain this
guide in a safe place for future reference.

PRODUCT REFERENCE GUIDE

© Copyright VE 2008

Due to our policy of continuous
product development, this
product is constantly evolving. It
is possible that some features or
procedures outlined here have
changed since this document
was written. If you are unsure
of any procedure shown here,
please contact us via the web at
[e-mail] to obtain
the most up to date information
before use. Include the batch
number, which can be found on a
sticker on the frame.

All pictures and diagrams herein
are provided for illustration
purposes only. Actual product,
colour or fabric may vary. VALCO
reserves the right to modify or

alter any specication or colour

without notice or obligation to
modify any product previously
purchased

FURTHER INFORMATION
North America only

www.valcobaby.com
1800 610 7850

Twin Latitude Car

Seat Adapter

Compatible with most Maxi Cosi Car Seats

B

D

INSTALLING YOUR TWIN MAXI
COSI CAR SEAT ADAPTOR:

FIGURE A

1. Begin preparing the Latitude stroller for the
Car Seat Adaptor by removing the canopy (hoods)
from the stroller and reclining the seats to their
fully reclined position (detailed instructions in the
Twin Latitude Stroller Instruction Manual).

2. Remove the extra hood, Male and Female
straps and Maxi Cosi strap from the packaging
and dispose of packaging responsibly.

FIGURE B

3. The extra hood is intended to shade the seat of
the stroller being used without a car seat.

4. Prepare the Hood for installation by rotating
the hood rods so they are aligned with the
corresponding connector pieces on the stroller
frame (where the twin hood was connected.) (1)

5. Simultaneously slide the hood rods onto the
corresponding raised pieces of the stroller frame
and lock into place. (2)

6. Snap the hood snaps onto the corresponding
snap pieces on the stroller seat back.

FIGURE C

7. The Male and Female straps are intended to
secure the car seat to the stroller frame.

8 Select a strap to secure around the side bar of
the Latitude stroller.

NOTE: ONLY SECURE THE STRAP TO THE SIDE OF
THE STROLLER WITHOUT THE HOOD.

FIGURE D

9. Fit the strap around the side bar of the Latitude
stroller.

A

Select a strap to secure to stroller

1

2

C

Male Buckle

Female Buckle

Maxi Cosi Strap

Hood

Seat Reclined

Bumper Bar

Wrap the strap around side bar