Valco baby T3 PLUS Product Reference Manual
Thank you for purchasing a quality Valco Baby product. Please read and follow the instructions outlined in this
guide carefully. Familiarise yourself with the construction and safety features; be sure that you understand all
the warnings and safety guidelines before use.
Important: Please read the following instructions carefully before assembling this product. Retain this
guide in a safe place for future reference.
PRODUCT REFERENCE GUIDE
© Copyright VE 2009
Due to our policy of continuous product
development, this product is constantly evolving.
It is possible that some features or procedures
outlined here have changed since this document
was written. If you are unsure of any procedure
shown here, please contact us via the web at
info@valco.com.au to obtain the most up to
date information before use. Include the batch
number, which can be found on a sticker on the
frame.
All pictures and diagrams herein are provided for
illustration purposes only. Actual product, colour
or fabric may vary. Valco Baby reserves the right
to modify or alter any specication or colour
without notice or obligation to modify any product
previously purchased
FURTHER INFORMATION
In Australia/New Zealand
www.veebee.com.au
In North America only
www.valcobaby.com
1800 610 7850
T3 PLUS
RECLINING STROLLER
STROLLER ASSEMBLY/OPENING
FIGURE A - ASSEMBLING YOUR STROLLER
1. Remove the carton contents carefully. Dispose of any
packaging materials thoughtfully.
2. Release the stroller from the locked position by lifting the
locking handle from locking rivet on the stroller frame.
HINT: You may have to squeeze the stroller legs and
handles closer together rst so as to release the tension
on the rivet.
3. Standing behind the stroller and holding it by the
handles, allow the wheels to fall forward.
4. With your foot, press down on the primary locking hinge
until the entire frame locks into the open position.
FIGURE B - ATTACHING THE REAR WHEELS
5. Identify the rear wheels by the red brake levers.
6. With the red levers facing to the rear, align the rear
wheel housing with the nylon housing on the rear frame
leg.
7. Insert rear wheel housing onto the rear leg and push
upward until you feel it lock into place.
8. Repeat for other leg.
IMPORTANT WARNING: ALWAYS TEST THAT ALL LATCHES ARE
SECURELY ENGAGED BEFORE USE.
FIGURE C - ATTACHING THE FRONT WHEELS
9. Insert the front swivel wheel over the housing on the
front leg. Repeat for the other wheel.
10. To x the front wheels in the non swivel position, turn
the wheel so that the two notches on both housings line
up at the front.
11. Press the swivel lock down rmly until it locks into
place. To unlock, lift the swivel lock with your foot lock to
release.
FIGURE D - ATTACHING THE HOOD
12. Fasten the hood Velcro straps around the top of the
frame (a). Clip the hood clip onto the frame just above
the folding hinge (b) and snap the side down into place
to secure.
13. Repeat for the other side.
14. Snap the back of the hood to the corresponding snaps
found on the back of the seat.
A
B
C
D
a
b
CLICK
2
3
4
11
Loading...