Valco Baby RAD-Bassinet User Manual

Product Reference Guide

Read and follow the instructions contained within carefully before use. Retain this guide in a safe and easily accessible place for future reference.

Drawings, pictures and specifications contained in this manual are for illustration purposes only – actual

product may vary. VALCO BABY reserves the right to alter any specification(s), colour and/or features without

prior notice or incurring any obligation to similarly alter products previously purchased.

Thank you for purchasing a quality VALCO product. Due to our policy of continuous product development, this model is constantly evolving. It is possible that some features or procedures outlined here have changed since this document was written. If you are unsure of any procedure outlined here please contact the store from which you purchased it to obtain the most up to date information, or contact us via the internet. See relevant web contact addresses on the back page.

Assembling / Opening your bassinet

Remove the bassinet from the carton and dispose of all packaging immediately and thoughtfully.

1. Lie the bassinet on a flat

surface “bottom up”

2. Swivel the two fixing arms

outward and upward till they lock into place

1. Push out each of the wire

frames to create the bassinet body.

2. Be sure to push each frame as

far as it can go – till the stoppers.

1. Insert the inner liner skirt into

the bassinet making sure that the holes fro the canopy are correctly aligned.

2. Secure by wrapping it over the

bassinet sides.

1. Fit the mattress cover to the

mattress.

2. Insert the mattress into the

bassinet.

1. Line up each of the fixing arms

with the corresponding housing located on either side of the stroller frame.

2. Insert the connecters into the

housing until the seat is securely in place.

1. Release and swivel the stability arm downward.

1. Connect and secure the stability

arm to the basket

1. To adjust your canopy,

simultaneously press the two grey buttons on the inside of the hood and move to the desired position.

1. To remove your bassinet,

simultaneously press the grey release buttons found on either side of the bassinet.

2. Lift the bassinet out of the

frame.

www.valco.com.au

www.valcobaby.com