![](/html/f0/f0e4/f0e4fb5ffa522a668c7a72ca676ec64fd596725c438651abc8e2fe1d54208296/bg1.png)
M212135EN-A
Regulatory
FCC and ISED
AP10A Access Point
Compliance
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
WARNING!
responsible for compliance could void the user’s authority to operate the equipment.
WARNING!
following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Changes or modifications to this equipment not expressly approved by the party
This device complies with part 15 of the FCC Rules. Operation is subject to the
ISED Compliance Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
This device has a whip antenna with a gain of 3 dBi.
Le présent appareil est conforme aux CNR d’lndustrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. l’appareil ne doit pas produire de brouillage, et
2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
Le présent appareil dispose d'une antenne fouet avec un gain de 3 dBi.
Safety
CAUTION!
maintained between the user and the device when the device is operating.
ATTENTION
doit être maintenue entre l'utilisateur et l'appareil lorsque l'appareil est en fonctionnement.
This device requires a separation distance of at least 20 cm. This distance must be
Cet appareil nécessite une distance de séparation d'au moins 20 cm. Cette distance
PUBLISHED BY
Vaisala Oyj
Vanha Nurmijärventie 21
FI-01670 Vantaa, Finland
Phone:+358 9 8949 1
© Vaisala 2018
All rights reserved. Any logos and/or product names are trademarks of Vaisala or its individual partners.
Any reproduction, transfer, distribution or storage of information contained in this document is strictly
prohibited. All specifications — technical included — are subject to change without notice.