Designer and Manufacturer of GPS Tracking System & Solutions. 1
T30C
Personal GPS Tracker User Manual
UVI GROUP CORPORATION Email/MSN: kevinchu81@yahoo.cn
Designer and Manufacturer of GPS Tracking System & Solutions. 3
Table of Contents
A. Working Directions········································································································4
B. System Introduction······································································································4
C. Installation·······················································································································5
1. Product Picture···········································································································5
2. Precaution before Installation·················································································6
3. Panel Description·······································································································6
4. Installation steps········································································································6
5. Battery Installation: ···································································································8
6. Open covers················································································································8
D. Operating Instructions··································································································9
1. Position Report Function·······················································································11
2. Tracking Function····································································································11
3. Stop tracking function.···························································································12
4. GPRS function of T30C:··························································································12
A. Set the APN····································································································12
B. Set the center IP and Port···········································································12
C. Set the terminal ID························································································12
Designer and Manufacturer of GPS Tracking System & Solutions. 4
A. Working Directions
Thank you for your purchase of T30C personal GPS Tracker. In order to realize the full functions of
this product, please read this manual carefully before starting to use the product.
1. This product can only be maintained and repaired by qualified professional service personnel. If
you detach this product for maintenance or repair, your warranty will be invalidated.
2. When connecting the other devices, read carefully their instruction manuals, so as to carry out
correct installation; do not connect incompatible device.
3. Please use genuine original parts and qualified batteries and peripheral equipments, so as to avoid
damage to this product.
4. As this product is a high-tech product, please read carefully this manual before starting to use the
product, so as to avoid inappropriate operation.
5. This product can work properly only when GSM communication is in good condition.
6. Please reduce electromagnetic wave interference to the product; and use it properly.
7. GPS communication is liable to be affected by environmental shielding; may fail to carry out
positioning during certain circumstances. It will resume the positioning function as soon as it leaves
the shielding environment. This is normal. Please do not worry when encountering such problem.
8. Each signal sent out from the system will be confirmed for successful transmission in the base
station of the mobile operator.
However, if system stoppage occurs or if the mobile telephone is preset to a switch off state by the
customer, it cannot ensure successful transmission.
9. For safety reason, do not tell the other people your T30C mobile number, without taking
precautions. Otherwise, your privacy may be compromised along with other safety problem.
B. System Introduction
T30C is a high-tech product through cooperation with mobile operators. It combines GPS Global
Positioning System and GSM communication system, which can clearly inform you the position &
situation of your car. GPS is the abbreviation for Global Positioning System, which based on 24
position location satellites around the earth orbit. Their locating precision can be kept within 10 to 15
meters. GSM is the second digital mobile communication system (GPRS, second and fifth digital
mobile communication system), and at present it is the mobile communication system that has the
largest coverage and owns the most number of users. This product combines GPS and GSM/GPRS
technologies together. It uses GPS system to locate your car, and sends the position/ situation report
back to you via GSM/GPRS communication system. With a delicate microphone, you can monitor the
present situation in your car from a faraway place. You can use the telephone remote control function
to set monitoring mode, which will report the situation of your car to you periodically.
Designer and Manufacturer of GPS Tracking System & Solutions. 5
C. Installation
1. Product Picture
Working condition：
The red LED is power light, it always light at SMS mode, it flash while connect the
Operation Platform at GPRS mode.
The blue LED is GSM light , if the light flash continuously , it means trackers is not
connected to the network ;but if the light go out for 3seconds , and then light for a half
second , that means trackers have be connected to the network , and work normally .
The green LED is GPS light , if the light go out for 1seconds , and then light for a
second ,it means trackers have not be connected to the network ; but if the light go out for
3seconds , and then light for a half second , that means trackers have be connected to the
network , and work normally .
Designer and Manufacturer of GPS Tracking System & Solutions. 6
2. Precaution before Installation
_ Check if all the parts are included.
_ Prepare a SIM card for GSM communication. Use some other mobile phone to confirm
that the PIN code has not been set and that it can dial out and receive telephone calls
without problem.
_Before install the SIM card; make sure to cut off power from the GPS Tracker unit. The
correct installation method is to push the tray completely into the GPS Tracker unit, until
you feel it is hooked by something.
3.
Panel Description
Left Button: SOS & mode switch button. When you press it for one second then loosen,
T30C will send SOS alarm. When you press it for a long time until left LED (red) flashing,
T30C will switch between SMS mode & GPRS mode.
Right Button: Turn on/off T30C Power. When T30C is off, press it to turn on T30C power.
When T30C is on, press it for a long time until left LED (red) flashing, it means T30C is
turned off.
Left LED (Red): Power
Middle LED (Green): GPS
Right LED (Blue): GSM
4. Installation steps
Step 1: Install SIM Card
Designer and Manufacturer of GPS Tracking System & Solutions. 7
Insert a SIM Card (must have GPRS service) into the back T30C.
※ Make sure to turn off the power before install the SIM card.
※ Make sure to deactivate the PIN code, so that the SIM card can operate without PIN
protection.
※ Before install the SIM card to the GPS Tracker, please use a mobile phone to make
sure the SIM card can make & receive phone calls without problem.
※ Before install the SIM card to the GPS Tracker, please use a mobile phone to empty
the SMS storage of the SIM card.
Step 2: Charge T30C for 4 hours
Step 3: Send SMS to set APN, Terminal ID, IP, Port
Step 4: Install TS610 client software
Step 5: Login our server platform with given account.
(Note:
When you install battery, please pay attention to the battery thimbles,
press them gently, so can avoid deforming or damaging the battery thimble
)
Designer and Manufacturer of GPS Tracking System & Solutions. 8
5. Battery Installation:
1. At first, you should connect the battery contacts carefully, (Figure 4)
2. And then, press battery into tracker (Note: Do not press very hard, it will damage
connects, Figure 5)
6. Open covers
(Figure 6, Figure7)
Figure 4 Figure 5
Figure 6 Figure 7
Designer and Manufacturer of GPS Tracking System & Solutions. 9
D. Operating Instructions
SMS protocol of T30C, the default password of T30C is 000000
SMS Instruction Format Remark
1 Request one position V******,000
2 Modify user password V******,001,######
****** is old password
###### is new password
3
Set the time internal of
position refresh
V******,002,XXX
XXX(3 digital) =000,stop
=[1,999] time internal (unit:
min)
4
Set SOS and Monitor
numbers. The First one for
SOS or monitor, and the
second one for monitor only.
When this button is pressed,
T30C will send the SOS and
position message to the
preset number.
V******,003,X,TelNumber
TelNumber: Preset Tel.
number, can set 2 numbers
(TelNumber must <20
digits )
X=1 SOS number , for SOS
alert or monitor the terminal
X=2 Monitor number,for
monitor only
5
Set low power alarm
When the T30C voltage is
lower than the preset value,
T30C will send one lower
power alarm SMS to the
control number.
V******,004,X
X (voltage preset value)
=0 , close (default )
=1 , <3.5V send SMS alarm
=2 , <3.6V send SMS alarm
=3 , <3.7V send SMS alarm
=4 , <3.8V send SMS alarm
=5 , <3.9V send SMS alarm
6
Set over speed alarm
When the T30C speed
higher than the preset value,
T30C will send one over
V******,005,XX
XX (the speed preset value)
=00 , close
=[01≤XX≤20] (unit:
10Km/h)
Designer and Manufacturer of GPS Tracking System & Solutions. 10
speed alarm SMS to the
control number.
7 Turn on/off the LED V******,007,X
X =1, turn on the LED
display (default)
=0, turn off the LED display
8 Inquire the system state V******,008
Including the software
version, password, interval,
speed limit, area limit, I/O
state, LED display state,
GPS state, SOS number,
control number, etc.
9
Switch between SMS mode
& GPRS mode
V******,013,X
X=0 SMS mode
X=1 GPRS mode
This command is effective in
GPRS mode.
10
Set the dialing number
These phone numbers can
request one position through
dialing.
V******,014,X,telnumber
X:=1-5 five numbers can
be preseted
11
Work mode select ：
（ GPRS&SMS mode all
acting）
V******,333,X
X=1、2、3、6,
X=0, running working ，
(Default setting)
X=1,working15 minutes ，
Stop 45 minutes, then cycle
X=2, working15 minutes ，
Stop 1 hour and 45 minutes,
then cycle
X=3, working15 minutes ，
Stop 2 hours and 45
minutes, then cycle
X=6, working15 minutes ，
Stop 5 hours and 45
minutes, then cycle
12 Reboot the terminal V******,502
13 Clear all parameter V******,888
Including all configure and
password
Notice: If you want to use low power alarm function or over
Designer and Manufacturer of GPS Tracking System & Solutions. 11
speed alarm function, you must set the time internal of
position refresh function first.
1.
Position Report Function
No matter where you are, when you want to know the position of the terminal, send a
SMS message or make a telephone call to the T30C; it will report its location back to you
by SMS.
1,Edit a message as following format, and then send it to T30C
Format: V+Password,+000
(Default password is: 000000)
For example: V000000,000
The T30C send back one SMS, which including the position information
Lat: 2232.6022N, Lon: 11402.2969E
This mean your position is on North Latitude 22 degree 32.6022 cent and East Longitude
114 degree 2.2969 cent
2,Apply for one position service by another way: you need preset the dialing
numbers( function 10)
(a) Make a cell phone call to T30C
(b) Then, listen the rings of T30C, it will hold off after two rings.
(c) Then, after seconds, the cell phone will receive the Position SMS.
2. Tracking Function
Tracking report function can be turned on or off according to the requirements of the
user. Tracking function will continually report terminal position until it get stop
command .In this tracking mode, T30C will send one position message at a preset time
interval.
Step1.Edit a message as following format, then send it to T30C:
----- V+Password,+002,+XXX
(Note: XXX Unit: preset minute interval
-- if XXX=000 it is STOP tracking)
For example: V000000,002,003
(It means is T30C will send Position Data every 3 minute.)
Step2. T30C will send back one SMS-----Set Time OK.
Designer and Manufacturer of GPS Tracking System & Solutions. 12
This SMS means that T30C is in tracking mode now and preset time interval is 3
minutes.
Step3. T30C will send back position SMS at preset time interval.
In this example, the SMS will send back at preset time interval: 3 minute
3.
Stop tracking function.
This function is used to turn off tracking report function.
Edit a message as following format, and then send it to T30C:
Format: V+passwaord,+002,+000
For example: V000000,002,000
4.
GPRS function of T30C:
If you want to use the GPRS functions of T30C, first you must set the GPRS parameters
(APN, Terminal ID, IP, port) in the SMS mode. Send V******, 013, 1 to turn T30C into SMS
mode
A. Set the APN
Send the SMS to the tracker as following format
----- V+Password,+011,+APN,+user name,+password
For example: V000000,011,CMNET
(CMNET has no user name, password)
B. Set the center IP and Port
Send the SMS to the tracker as following format
----- V+Password,+012,+IP:Port
For example: V000000,012,121.34.241.160:8086
C. Set the terminal ID
Send the SMS to the tracker as following format
----- V+Password,+015,+terminal ID
The terminal ID is a 15 bit character string; it can be letter in capitalization or number.
For example: V000000,015,VICZONE00000001
After setting the parameters, send V******, 013,1 to turn T30C to GPRS mode.
Loading...