Fixed Subscriber Unit Installation Manual Table of Contents
i
Proprietary Statement
UTStarcom Inc. has prepared this manual for use by customers, UTStarcom
personnel, and licensees. The information contained herein is the property of
UTStarcom Inc. and shall neither be reproduced in whole nor in part without
prior written approval from UTStarcom Inc.
UTStarcom reserves the right to make changes without notice to the
specifications and materials contained herein, and shall not be responsible for
any damages caused by reliance on the material as presented, including, but
not limited to, typographical, arithmetic, and listing errors.
Trademarks
All trademarks and service marks used in this document belong to their
respective owners.
Warranty and Return Policy
Refer to the terms and conditions of the contract for warranty and return
policy details.
Customer Service
Refer to the terms and conditions of the contract for customer service policy
details, or call the local UTStarcom Facility. UTStarcom’s Facilities are listed
below:
Table of Contents Fixed Subscriber Unit Installation Manual
ii
245 Tianping Rd. Jinguo Garden 803
Shanghai, 200030, P.R. China
Tel. 86-21-6433-6223
Fax 86-21-6433-6226
UST Guangdong Subsidiary
352 Tianhe Road, 21F
Guangdong, 510620, P.R. China
Tel. 86-20-8758-4025
Fax 86-20-89753-7411
UTStarcom (Hangzhou) Ltd.
118 Moganshan Rd. 2nd floor
Hangzhou, 310005, P.R. China
Tel. 86-571-880-0350
or 86-571-880-0369
Fax 86-571-805-6499
International Facilities and Operations
UTStarcom, Singapore Office
ACTEL Communications
141 Middle Road #06-02
GSM Building, Singapore 188976
Tel. 65-334-6602
Fax 65-334-6606
UTStarcom, Thailand Office
For You Infosys Co., Ltd
47/15 Soi Lardprao 122
Bangkapi Bangkok 10310
Tel. 66-2-539-7140
or 66-2-934-0179 ext 80
Fax 66-2-539-7431
4 Yunshan Road East, North River Yunshan
Industry Zone
Huizhou, Guangdong 516001, P.R. China
Tel. 86-752-280-8868
or 86-752-280-8818
Fax 86-20-280-8838
Nantian UTStarcom Inc.
43 Tianmushan Rd.
Hangzhou, 310007, P.R.China
Tel. 86-571-2314
Fax 86-571-797-5149
UTStarcom, India Office
W.S. Telesystems Limited
Dr. Brownamma Towers
11 Floor, 70/1, Mission Road
Bangalore - 560 027, India
Tel. 91-80-227-4444
Fax 91-80-222-5268
10/03/97 Release 1.00
Airstar-Wireless Local Loop
Fixed Subscriber Unit Installation Manual Table of Contents
iii
WARNING! FCC RF EXPOSURE COMPLIANCE
This PCS base station has been tested and complies with the Federal Communications
Commission (FCC) RF exposure limits for General Population/Uncontrolled exposure
environment. In addition, it complies with the following Standards and Guidelines:
• FCC 96-326, Guidelines for Evaluating the Environmental Effects of RadioFrequency Radiation.
• FCC OET Bulletin 65 Edition 01-01 (2001) Supplement C, Evaluating Compliance
with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic
Fields.
• ANSI/IEEE C95.1-1992, IEEE Standard for Safety Levels with Respect to Human
Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.
• ANSI/IEEE C95.3-1992, IEEE Recommended Practice for the Measurement of
Potentially Hazardous Electromagnetic Fields - RF and Microwave.
Antenna Installation Requirement:
The antenna must be installed and located on a roof top site, pole, or building structure away
from users and bystanders. It must be mounted in a manner to ensure that a minimum
separation distance of 20cm is normally maintained between all users and bystanders.
Important Safety Instructions
• Read and follow all warning notices and instructions marked on the product or included in this
document.
• This product is intended to be used with a three-wire grounding type plug - a plug that has a
grounding pin. This is a safety feature. Equipment grounding is vital to ensure safe operation.
Do not defeat the purpose of the grounding type plug by modifying the plug or using an adapter.
Prior to installation, use an outlet tester or voltmeter to check AC receptacle for the presence of
earth ground. If the receptacle is not properly grounded, the installation must not continue until a
qualified electrician can determine another method of grounding the equipment.
• Do not allow anything to rest on the power or line cords and do not located the product where the
power or line cords could be stepped on.
• This product must be serviced only by a qualified service technician.
• Special cables, which may be required by the regulatory inspection authority for the installation
site, are the responsibility of the customer.
Release 1.00 10/03/97
Airstar-Wireless Local Loop
Table of Contents Fixed Subscriber Unit Installation Manual
iv
• When installed in the final configuration, the product must comply with the applicable safety
standards and regulatory requirements of the country in which it is installed. If necessary,
consult with the appropriate regulatory agencies and inspection authorities to ensure compliance.
• A rare phenomenon can create a voltage potential between the earth grounds of two or more
locations. If products installed in separate locations are interconnected, the voltage potential may
cause a hazardous condition. Consult a qualified electrical consultant to determine whether this
phenomenon exists and, if necessary, implement corrective action prior to interconnecting the
products.
• Install this product in a location protected from humidity, dust, and extreme heat. This will
ensure that internal parts are not damaged. If liquids are spilled on the product, contact a
qualified service technician.
• Use this product only with UTStarcom approved or recommended adapters and batteries.
• Do not attempt to remove the cover. Contact a qualified service technician for servicing the
product.
10/03/97 Release 1.00
Airstar-Wireless Local Loop
Fixed Subscriber Unit Installation Manual Table of Contents
v
CONTENTS
1. INTRODUCTION TO THIS MANUAL .................................................................................................................. 1-1
2. GENERAL DESCRIPTION...................................................................................................................................... 2-3
3. SYSTEM CONSTRUCTION..................................................................................................................................... 3-9
4.1.3 Antenna Type Determination Guidelines ..................................................................................................... 4-13
4.1.4 Main Unit Site Selection............................................................................................................................... 4-13
4.1.5 Installation Accessories, Standard and Special Tools ................................................................................. 4-14
5. ACRONYM AND ABBREVIATION LIST ........................................................................................................... 5-33
APPENDIX A : SPECIFICATIONS.............................................................................................................................A-1
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
F
IGURE
2-1 : O
VERVIEW OF
2-2 : O
UTGOING CALL
2-3 : I
NCOMING CALLS
2-4 : A
UTHENTICATION
3-1 : FSU - M
4-1 : FSU I
NSTALLATION FLOW CHART
4-2 : FSUJ M
4-3 : WLLSO S
4-4 : WLLSO S
4-5 : S
TRIPPED COAXIAL CABLE
4-6 : FSU A
4-7 : A
4-8 : A
4-9 : E
4-10 : C
4-11 : FSU
4-12 : A
4-13 : T
4-14 : B