Wire Extension Kit
Installation Guide
For Models 9910APV & 1010APV
The Wire Extension Kit provides up to 30 feet of additional wiring for remote-mounting your solar panel
on a roof top, wall, or fascia board. Up to two Wire Kits (60 feet) can be added to a panel (which
already includes 30 feet of wire), for a maximum of 90 feet between the panel and the fan.
Note: Do not add more than two Wire Kits, or exceed 90 feet total distance between the Panel and the
Fan, the result could be reduced performance.
Installation of the Wire Extension Kit
fig. 1 fig. 2 fig. 3
fig. 4 fig. 5 fig. 6
Step 1: Connect the female
connectors of the Wire Extension
kit directly to the fan motor as
described in the APV installation
instructions (fig. 1).
Step 4: Place the black wire
connection into the remaining
opening in the protective casing
(fig. 4).
Step 2: Insert the male connectors
from the Wire Extension Kit into the
female connectors at the end of
the solar panel wire (fig. 2)
Step 5: Press the casing down
over the black wire and snap shut
(fig. 5).
Step 3: Slide the red wire connection
into one of the protective casings (fig.
3). Press the casing down over the
red wire firmly and snap shut (fig. 5).
Step 6: The wire extension
connection is now secure and
weather-proof (fig. 6).
US Sunlight Corp. 5625-B Brisa Street, Livermore, CA 94550 1-866-446-0966
www.ussunlight.com
Loading...