Urschel CCL User Manual

Urschel® Model CCL
Lattice Slicer
SPECIFICATIONS
The Model CCL is equipped with manganese aluminum bronze contact parts.
Length: . . . . . . . . . . . . . . . . . . . . . . 48.03" (1220 mm)
Width: . . . . . . . . . . . . . . . . . . . . . . . . 35.26" (896 mm)
Height: . . . . . . . . . . . . . . . . . . . . . . . 32.68" (830 mm)
Net Weight: . . . . . . . . . . . . . . . . . . . . . 540 lb (245 kg)
Motor: . . . . . . . . . . . . . . . 2 HP (1.5 kW) or 5 HP (3.7 kW)
APPLICATIONS
The Model CCL slicer produces lattice cuts of varying thickness. Both sides of the slice have crinkles, with the crinkles on each side of the slice running approximately 90° to each other. Uses involve lattice potato chips and thicker potato waffle fries.
Lattice slicing is a unique application. Proper feeding of the machine is necessary to ensure continuous production. Tempered high quality oval or flat shaped potatoes measuring between 2 –4 inches (51 – 102 mm) are best-suited.
Note: The Model CC Slicer can be converted to a Model CCL Lattice Slicer by purchasing the recommended set of parts. Contact your local Urschel representative for more information.
Product
Knife
Product
Holding Tube
MODEL CCL
OPERATING PRINCIPLE
Potatoes are fed into a revolving impeller assembly consisting of four rotating potato holding tubes. The tubes allow the potato to be rotated in a vertical axis while being revolved in a radial direction. Centrifugal force holds the potatoes tightly against the inside surface of the spherical-shaped slicing head. As the potatoes rotate inside the slicing head, they make an approximate one-quarter turn between each of the four crinkle knife stations. This results in intersecting crinkles on each side of the slice.
TYPES OF CUTS
Fine Lattice: Translucent appearance
with small lattice holes visible after frying. 8 corrugations per inch (25.4 mm). Approximately .125" (3.2 mm) peak to peak.
Coarse Lattice: Small lattice holes visible. 5.7 corrugations per inch (25.4 mm). Approximately .175" (4.4 mm) peak to peak.
Deep Lattice: Slightly larger lattice holes. 2.25 corruga tion s per inch (25.4 mm). Approximately .446" (11.2 mm) peak to peak.
If your product application is not mentioned on this page, contact your local Urschel representative to determine the most effective solution to your size reduction needs.
(over)
Loading...