
G - Long Bolts * 1.25*4.5CM 4
H - Short Bolts * 1.25*1.5CM 4
K - Parts Pack With two pairs of white
gloves and blue plastic shoe’s cover.
This page lists all the contents
included in the box. Please take time
to identify the hardware as well as the
individual components of this product.
As you unpack and prepare for
assembly, place the contents on a
carpeted or padded area to protect
them from damage.
J. Allen Wrench (Included)

STEP THREE: Firmly press fit the stems of 5
casters into holes on the underside of the
base. Fit bottom of gas lift into hole of base
as shown.
STEP FOUR: Fit top of gas lift into
corresponding hole on the bottom of the seat
assembly as shown.
NOTE : Finalize assembly by sitting heavily
on the chair a few times. This will secure all
the component connections.
STEP TWO: Attach armrests to seat as
shown. Secure armrests with 4 long bolts, 8
spring washers, using an allen wrench.
STEP ONE: Attach seat adjuster to seat as
shown. Make sure arrow on adjuster points
toward the front edge of the seat. Secure
adjuster with 4 short bolts and 4 flat washers
as shown, using an allen wrench.
NOTE: Make
sure arrow on
adjuster points
towards front

Clean surfaces with a dry or damp soft
cloth.
Do not use abrasive cleaners.
2 LOCKING THE SEAT:
While sitting in the chair, lean your weight
forward and push the lever in.
3 UNLOCKING THE SEAT:
While sitting in the chair, lean you weight
forward and pull the lever out.
4 ADJUSTING THE TENSION:
Tighten the knob to increase the back
tension (less rocking). Loosen the knob to
decrease the back tensions (more
rocking).
1 HEIGHT ADJUSTMENT:
while sitting in the chair, pull the lever
up to lower the seat. To raise the seat,
take your weight off the chair and pull the
lever up.