Uplink 5200 Installation & User Manual
INSTALLATION &
USER’S GUIDE
®
BROADBAND
ALARM COMMUNICATOR
5200
PRODUCT ID # 2033325200XX00
®
5200
®
5200
© 2013 Uplink Security, LLC. All rights reserved. Uplink is a trademark of Uplink Security, LLC.
No part of this publication may be reproduced or used in any form without permission
in writing from Uplink. This includes electronic or mechanical means, such as
photocopying, recording, or information storage and retrieval systems. The material in
this manual is subject to change without notice.
Uplink reserves the right to make changes to any software or product to improve
reliability, function or design.
Uplink is a registered trademark of Uplink Security, LLC. All other trademarks are the
property of their respective owners.
PRODUCT ID # 2033325200XX00
BROADBAND
ALARM COMMUNICATOR
2
BROADBAND
ALARM COMMUNICATOR
TABLE OF CONTENTS
Table of Contents ....................................................................................2
Introduction .............................................................................................3
Installation ...............................................................................................4
Connections Used ................................................................................... 5
Activation .................................................................................................6
Network Conguration ............................................................................7
Dialing The Alarm System For
Touch-Tone Phone Remote
Control & Upload And Download
Over Dial Up Connection .........................................................................8
Troubleshooting ....................................................................................... 9-10
Standard 12-Month Limited Warranty .....................................................11-12
Fcc & Industry Canada Regulatory Compliance .....................................13
FCC RF Exposure Information ................................................................14
Technical Support ....................................................................................15
®
5200
3
INTRODUCTION
The Uplink® 5200 Broadband communicator expands the capability of a Contact
ID dial-up alarm system by enabling it to transmit signals over the internet. It is a
cost-effective solution where there is broadband internet service. The 5200 can be
used for retrots on existing alarm systems, takeovers and new installations.
The 5200 converts the dialer output of an alarm system to an IP signal that can
be transmitted securely over the internet to an Uplink server. A connection is then
made to the central station to deliver the alarm signal. The 5200 supports two-way
voice sessions as well as remote programming for most systems.
Installation is fast and easy. Using the provided cables, the 5200 communicator is
hardwired between alarm dialer and internet service.
BROADBAND
ALARM COMMUNICATOR
4
INSTALLATION
The physical installation of the Uplink 5200 is simple, but it is important to plan
it beforehand. The unit requires power, a connection to the alarm panel, and a
connection to the Internet. Choose a location where the 5200 can be connected
to all of these things. In most cases, the 5200 should be placed near the alarm
panel, but in some installations it may be easier to place it near the router and run
a long phone cord to the alarm panel. Connect the Alarm Broadband Adapter
to the Internet using either an Ethernet cord to the router, a wireless bridge, or a
power line bridge. (If the alarm panel was connected to a multi-pair phone line with
line seizure, the line-seizure pair can be used as a phone connection between the
panel and a phone jack near the customer’s router)
Loading...