upcom UC-120-FWA Assembly Manual

UPCOM UC-120-FWA

ASSEMBLY MANUAL

UPCOM TECHNOLOGIES INC.
SAN JOSE, CA - USA ©˙2007

ASSEMBLY MANUAL UC-120-FWA

© 2010 UPCOM TECHNOLOGIES, INC

is document is property of UPCOM TECHNOLOGIES, INC and is delivered on the express condi­tion that it not be disclosed, reproduced in whole or in part, or used for the manufacture for anyone other
than UPCOM without written consent, and that right is granted to disclose or so use any information on
said document.

Notice

e information in this document was believed to be correct at the time of publication, and every effort was
made to ensure that the most current information was shipped with each equipment. If subsequent modifi­cations were made to your unit, and you need information on these, please contact the UPCOM documen­tation department

If you have technical or editorial comments concerning this manual, please write them on photocopies of
the relevant pages and send them to the documentation department or contact the Customer Service De­partment. is assistance will be greatly appreciated

Manual Applicability

is is the general operating manual for UPCOM 1.2m Fly-Away Antennas. Please make sure that the
correct manual is being used by verifying part number and serial number with UPCOM technical support
team or your local distributor.

Be prepared to furnish:

Serial Number

Frequency Range

Symbols

e following warning and caution symbols are used throughout this manual:

Warning: A hazard exists that may result in personal injury or loss of life.

Caution: Failure to follow the procedures given may result in damage to the equipment.

| III

WARNING

e system containers should be unpacked and inspected at the earliest date to insure that all material ♦
has been received and is in good condition.

Any damage to materials while in transit should be immediately directed to the freight carrier. He will ♦
instruct you on matters regarding any freight damage claims.

iv | TABLE OF CONTENTS

Table of Contents

Contents

Notice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii

Manual Applicability . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii

Symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii

WARNING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iii

1 Getting Started 1

2 Antenna Asembly 2

3 Antenna Pointing 13

4 Maintenance 14

11 Specications 15

| 1

1

Getting Started

If you need help

UPCOM and its distributors stand by every product sold . If you need help please contact your local dis­tributor or UPCOM directly at:

+1.408.329.4158

or by e-mail:

[e-mail]

Manual Updates

From time to time, new versions of software may require slight changes to the material presented in this
document. Check inside the back cover for supplementary pages that may have been added to keep the
manual up to date

2 | UC-120-FWA ASSEMBLY MANUAL

2

Antenna Asembly

Caution: During the assembly procedure, the sequence of instructions must
be followed. Do Not Tighten Any Hardware Until Instructed . Refer to the
antenna assembly parts list and the steps shown below.

UC-120-FWA ASSEMBLY MANUAL | 3

Remove the antenna base from packaging and place it over the oor as

showed in the picture