UPair Fairy Instruction Manual

s

Upair Fairy

s

.

s

How to connect to UPair APP

1.Turn on the remote controller and the aircraft, wait 30 seconds.

2.For iPhone:
Open Wifi and choose UPair XXX. Password: 12341234

3.For Android phone: Connect your android phone and RC via USB data cable,
then choose MTP, select Setting--NETWORK--More--open the USB tethering

(Note:For different Android mobile phone models,selections may varies)

Upair app support IOS8.0 and Android 4.4 or above system.

are

lf you have questions,please contact us:www.upairdrone.com

1

Place your mobile device into the clamp
and adjust it so that the mobile device is

held securely in place

7.Manual Take off

Display on APP

6.

lf you have questions,please contact us:www.upairdrone.com

[1]H:Altitude “0?

[3]GPS signal should be over 9 satellites

[5]V.S:Vertical velocity "0"m/s

[2]D:Home distance“0”

[4]H.S:Horizontal velocity "0"m/s

[6]V.C: Controller voltage "12.6V"

* It can take off when it achieves the above conditions (espicially the Altitude is

“0?, and the satellite is over “9?). Otherwise the aircraft cannot use position

hold or auto-return function. (GPS signals can not be searched in-door)

After self-calibration, you can pull both control sticks to the bottom inside

comers to start the motors. Release the sticks once the motors are unlocked.

When the aircraft is unlocked, please firstly display the self-examining

process of

flying altitude. Then you can combine stick command to unlock the motors. Let

the throttle raise slowly.

......

lf you have questions,please contact us:www.upairdrone.com

2

3