Uniview DH-IBF-680BN-V3, DH-IBF-680WN-V3 Specsheet

4-In-1 Camera

(CVI/TVI/AHD/Analog)

Infrared Bullet

► 2 Megapixel (1080P) HD
► Day & Night
► Weatherproof (Indoor/Outdoor)

1) Loosen the side screw on the bracket and mount the

base to a flat surface on ceiling or wall using 3 screw

holes. For exposable wiring, simply use the wire
opening on the edge of the base to feed through the wire;
for inexposable wiring, drill a 1/2” hole and feed wire

harness through it until the base can be mounted flat on

the surface.

One-Screw

Bal l & Socket Mount

Output Control: (Black spot is position of dip switch.)

2) Once the base has been mounted, adjust the ball and
socket to a desired camera angle and fully tighten the

side screw on the bracket to ensure a secure fit.

ON

ON

ON

ON

Image Sensor

Frame Rate

Signal System

Horizontal Resolution

IR LED

IR Distance

Minimum Illumination

Electronic Shutter Speed

S/N Ratio

Lens

Day/Night

Weatherproof Rating

Video Output

Power Consumption

Power Supply

Camera Dimensions

1/2.7” 2 Megapixel CMOS

30fps @ 1080P

NTSC

1920 (H) x 1080 (V)
36 Pieces (850nm)
100ft Depending on Scene Reflectance
0 Lux (with IRs ON)
1/60 ~ 1/30,000 Seconds (Auto)
More Than 50dB

3.6mm Fixed Lens
Auto (Built-in ICR)
IP66

1.0Vp-p, 75Ω Composite BNC

Less Than 4 Watts

DC 12 Volt ± 10%

2.76” (Max Height) x 7.13” (Max Length)

► Do not attempt to service this video product by
yourself, as taking apart the camera may expose
you to dangerous voltage or other hazards.

► Please comply with all electrical safety
standards during installation and operation.

► In order to prevent damage caused by fire or

electrical shock, please do not submerge camera
in water or expose any open parts to liquid.

► Do not expose the lens directly to the sun or to
strong light as this may damage the image sensor.

► There are some sophisticated parts inside this
camera, therefore always handle with care in
order to avoid any internal damages to the
camera.

► Make sure to use the appropriate power supply
and that the power is plugged into the camera
correctly and securely. Do not switch on power
until after the camera connection is complete.

1 2

CVBS

1 2

CVI

1 2

TVI

1 2

AHD

NO VIDEO OUTPUT:

► Check the power cable to the power box or wall outlet. Make
sure the power connections are secure.

► If you are using a multiple output power box, make sure the
power switch is in the “ON” position and that all fuses are
illuminated.

► If you are using a multiple output power box, make sure the
POSITIVE (+) and NEGATIVE (-) wires are properly connected.

► Check the BNC video cable running from the camera to the
video input on the DVR or display. If you are using pre-made
cable, make sure the BNC connectons are secure. If you are
using a spool of cable (RG59), make sure the outer copper wire

is not touching the center pin when fitting the cable ends with

BNC connectors.