Universal Weight Electronics ZS Series, ZS-600, ZS-1200, ZS-3000, ZS-2500 Operation Manual
INDEX
Installation 2
Specifications 3
Key Layout & Functions 4
Internal Functions 6
Initial Setup 8
Instructions for Use 11
Error Codes & Troubleshooting 15
Daily Care & Maintenance 17
1
INSTALLATION
1. Check and make sure that the following accessories are included:
Operation Manual X 1 ZS Scale X 1
Stainless Steel Platter X 1
Power Adaptor X 1
Contact your dealer if any item is missing.
2. Install stainless steel platter.
3. Power the scale:
Insert one 9V battery into the battery compartment or apply the
external power adaptor.
Before plugging the power adaptor into the electricity outlet,
check and make sure the input voltage of the power adaptor
matches with the output voltage of the outlet.
If do not match, please do not plug in the adaptor and contact
your dealer.
** When the power adaptor is being used, please remove all the
batteries from the battery compartment. Failure to do so might
cause a battery leak/explosion or damages to the scale. Do not
use any rechargeable battery. This scale does not recharge any
batteries.
2
SPECIFICATIONS
Model
Capacity
Division
ZS-600
600g/1lb 5.195oz
0.1g/0.005oz
ZS-1200
1200g/2lb 10.40oz
0.2g/0.01oz
ZS-3000
3000g/6lb 9.98oz
0.5g/0.02oz
ZS-2500
2500g/5lb 8.50oz
1g/0.05oz
Power
Source
9V battery or External Power Adaptor
Max. Zero
Range
2% of Rated capacity
Max. Tare
Range
100% of Rated capacity (Subtractive)
Weight Units
(Note A)
Metric (g), Avoirdupois (lb & oz) & Taiwanese (tg)
Operation
Environment
0o~40oC (32o~104oF), Non-condensed. R.H.≤ 85%
Specifications subject to change without notice
NOTE A:
To comply with the law of certain countries, Avoirdupois and
Taiwanese weight units may be disabled. Contact your dealer for
more information.
3
KEY LAYOUT & FUNCTIONS
OFF KEY
Press this key to turn scale off.
ON/ZERO KEY
Press this key to turn scale on or set weight to zero.
TARE KEY
Press this key to tare off the weight of a container.
MODE KEY
Press this key to switch between weight units.
4
KEY LAYOUT & FUNCTIONS
ZERO INDICATOR
This indicator appears to indicate zero weight status.
MINUS INDICATOR
This indicator appears to indicate negative weight values.
LO-BAT INDICATOR
When this indicator appears, recharge the scale immediately.
WEIGHT INDICATOR
Displays the weight of the item placed on the scale.
NET INDICATOR
This indicator appears to indicate the tare function is in
operation and weight shown is net weight.
METRIC INDICATOR
This indicator appears to indicate the metric weight unit is in
use.
AVOIRDUPOIS UNITS INDICATOR
This indicator appears to indicate the avoirdupois weight unit
is in use.
5
Loading...