Thank you for purchasing DUCKY SPLASH from UNIVERSAL SPACE. We hope
you enjoy the product.
This manual contains valuable information about how to operate and maintain your game
machine properly and safely. It is intended for the owner and/or personnel in charge of
product operation. Carefully read and understand the instructions.
If you need any help during installation and setup please utilize this manual and
troubleshooting guide. If the product fails to function properly,
should under no circumstance attempt to service the machine
manufacturer for help.
non-technical personnel
. Contact your distributor or
Before use, please read
IMPORTANT SAFETY INSTRUCTIONS.
IMPORTANT SAFETY INSTRUCTIONS
To ensure the safe usage of this product, carefully read and
understand these instructions before operating your game.
Save these instructions for future reference.
Use this product only as described in this manual. Other uses not recommended may cause
fire, electric shock or personal injury. Unplug the game from the outlet when not in use,
when moving from one location to another, and before cleaning/servicing.
Explanations which require special attention are indicated by signs of warning. Depending
on the potential hazardous degree, the terms:
NOTE: A NOTE indicates useful hints or information about product usage.
NOTICE: A NOTICE indicates potential damage to product and how to avoid the problem.
WARNING: A WARNING indicates a potential for product damage or serious personal Injury.
NOTE, NOTICE, and WARNING are used.
It is important to understand the meaning of the following HAZARD SIGNS
High Voltage and Shock Hazard:
High voltage can cause electric shock.
Turn off/unplug power before servicing.
High Temperature Hazard:
This part may cause scalding.
Do not touch. Surface may be hot.
before continuing:
3
No Touching Hazard:
require or perform tasks which are not explained in this manual.
servicing.
This part may be hot or can cause electric shock.
Do not touch.
Use the following safety guidelines to help ensure your own personal safety and to help
protect your equipment and surrounding environment from potential damage.
This product is an indoor game machine. Do not install outdoors.
Avoid installing in the following places to prevent fire, electric shock, injury and/or
machine malfunctioning:
Places subject to rain/moisture, or places subject to high humidity.
Places subject to direct sunlight, or places subject to extremely hot or cold
temperatures to ensure that it is used within the specified operating range.
Places where inflammable gas may be present or in the vicinity of highly
inflammable/volatile chemicals or items that can easily catch fire
On unstable or sloped surfaces. The machine may topple or cause unforeseen
accidents.
Vicinity of fire exits, fire extinguishers etc that may block/prevent safety measures
WARNING
Non-technical personnel who do not have technical knowledge and
Expertise should refrain from performing such work that this manual
Failing to comply can cause severe accidents such as electric shock or
other serious injuries.
WARNING: To reduce the risk of fire, electric shock or personal injury,
unplug or disconnect the machine from the power supply before
Note: The contents of this manual may be updated without notice.
4
1. SPECIFICATIONS
Rated power supply:220V 50/60Hz
Min. Power consumption: 120W
Max. Power consumption
Dimensions
Weight
:W1930×D1000×H2090.3 (mm)
:About 215Kg
: 6300W
NOTICE: After turning off the game, please wait at least 1 minute before
restarting again.
Note: Game parameters are subject to change without notice.
5
2. PACKAGE CONTENTS
/250V(T10A/125V)
T5A/250V(T10A/125V)
Open the package and make sure all the items are included:
1 x Body Assembly
Following accessories
No.Part No.Name Spec.Qty.IllustrationNote
1
2
3
4
5
6
7
D108-806-000
D108-453-000
D108-461-000
D108-734-000
D108-405-000
D108-403-000
D108-464-000
D108-408-000
AC power 10A/250V 1.8m1
T5A
Fuse
ManualEnglish1
Key 1712Service door
Key 22222Coin box door
Spanner 1
Ducky 20
Φ5-20
Φ6-30
1
Choose by
area
Choose by
area
(Recommended number of Ducks to use in game: 6 per side)
If any items are found to be missing, please contact your sales representative
for help immediately.
NOTE: Part models are subject to change without notice.
6
3. PART NAMES
2D VIEW
3D VIEW
7
4. SET UP & INSTALLATION
This product is an indoor game machine. Do not install outdoors.
Refer to IMPORTANT SAFETY INSTRUCTIONS for places to avoid
Place the unit on a dry level surface
Ventilation openings in the back of the unit must not be obstructed by objects or by wall.
4.1 Play Zone
This machine requires space for playing and for maintenance as shown below.
Leave space around the game upon installation:
Service area
Play area
安全遮板
: 50cm
: 100cm
8
4.2 Level Adjustment
Leveler
Caster
About 5mm
Move
Fix
Install this machine on a flat surface. Adjust levers to lift casters off the ground to level the
. If the game is installed on an unsuitable floor, it could cause a malfunction.
game
To fix the game, adjust the Leveler down until it touches the floor, lifting the casters off the
ground by 5mm. Repeat the same for all levelers.
NOTICE
Make sure the machine is level with the ground and all the
adjustable legs should stick to the floor closely.
9
4.3 Transporting the Game
If you need to move the game, adjust the levelers back to an “up” position so the casters
touch the ground.
Leveler Caster
Move Fix
NOTICE
Be careful not to damage the machine during transport.
The machine should be handled with care when bringing it down from a higher
level.
Always unplug the game before moving.
Keep the machine in upright position during transport.
For longer distance transport, package the game properly to prevent damages.
Drain all water from the game before transporting.
4.4 Connecting Power
WARNING: Check the voltage rating before you connect the equipment to
an electrical outlet to ensure that the required voltage and frequency match
the available power source. Please refer the label of the machine.
Do not plug the equipment power cables into an electrical outlet if the power cable is
damaged.
Avoid putting many loads on one electrical outlet as it could generate heat and fire
resulting from overload.
Connect the grounding conductor to the earth terminal (GND):
WARNING
Ensure no heavy objects rest on the power cord. Check to make sure the game cabinet does
not sit on the power cord as this could damage the cord and become hazardous.
To disconnect the game, grip the plug and pull it from the wall outlet. Never pull by the cord.
To prevent electric shock, do not touch the power plug when hand is wet.
Ensure that nothing rests on the power cord and that it is not located where it can be
stepped on or tripped over.
10
5. HOW TO PLAY
Ducky Splash is a 1- 2 player water shooting game for
children and the whole family!
The object of the game is to use the Dino water guns to
shoot rubber ducks into the 2 tunnel entrances. Players
must shoot as many ducks as possible into their own
entrance before the time runs out!
Single Player Mode
Pick a side (left side OR right side), and
insert coin(s) to start.
Water gun is activated and the timer
starts counting down.
Aim and shoot ducks into the entrance ON
YOUR SIDE to earn points
(Ducks entering the wrong entrance will
not give points)
Each time a duck passes through the
entrance, player’s score increases.
Once time is up, tickets will be awarded
based on the final score.
2- Player Match Mode
Insert coin(s) at the same time to begin together.
Both water guns are activated and the timer starts counting down.
Shoot ducks into entrance of each corresponding side to earn points
(Shooting ducks into the opponent’s entrance will give them extra points!)
Once time is up, winner receives all the tickets. (Loser will be awarded mercy tickets.)
Note: Maximum memory score for each water gun is 1000 when there is no ticket payout.
11
6. GAME OPTIONS
6.1 Switching Control Signals
Please refer to the I/O chart and schematics included with the game.
To adjust DIP settings, please refer to the
LETTERS.
Main Board :
I/O chart. The initial settings are in CAPITAL
12
Test Mode:
Press and hold the TEST button on the main board to enter Test Mode.
LED Display
Left score LED<1>3-1/Left time LED<1>6-5
Right score LED<2>3-1/Right time LED<2>6-5
(Flashing): Left credit LED<1>6-5 Right credit LED<2>6-5
Testing - Options
LED displays segment scan, digit scan and shows <1, 2, 3, 4, 5, 6, 7, 8> and <87654321> -
To check LED display.
Press TEST button again and LED displays 1 - shows the LED 1and LED2 of 1# in DIP SW.
Press TEST button again and LED displays 2 - shows the number of on-off SW
Press TEST button again and LED displays 3. Press IN1-40 to test sound/music.
Press TEST button and LED displays 4 - Corresponding lighting output.
Press TEST button again and LED displays 5, - Lighting moves slowly.
Error Codes
The following error codes will display if there is an error in the input signal:
E.01 Ticket. Reset error
E.83/E.84 Coin Mech signal error
E.04 Left entrance sensor error
E.07 Right entrance sensor error
13
Loading...
+ 30 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.