MODEL USI-2413
Smoke & Fire Alarm
Signaling Device Kit for
Hearing Impaired
OWNERS INSTRUCTIONS
The USI-2413 has been assembled for the purpose of meeting the American
Disabilities Act requirement s for visual signaling devices for the hearing impaired.
This kit contains (1) Model USI-1213 AC Smoke Alarm, (1) Model USI-960 Relay
Module and (1) Model USI-2177 177 Candela Strobe light.
INSTALLATION
The following wiring diagram can be used as a reference when installing this kit
and wiring the three units together.
IMPORTANT
Prior to installation, you must thoroughly read and understand each individual
component manual.
INSTALLATION
Installation of this unit must conform to the electrical codes in
your area; Article 760 of the National Electrical Code, NFPA 72,
101; SBC (SBCCI); UBC (ICBO); NBC (BOCA): OTFDC (CABO),
and any other local or building codes that may apply. Wiring and
installation must be performed by a licensed electrician. Failure
to follow these guidelines may result in injury or property damage.
This unit must be powered by a 24-hour, 120V AC 60Hz circuit. Be
sure the circuit cannot be turned off by a switch, dimmer or ground
fault circuit interrupter. Failure to connect this unit to a 24-hour
circuit may prevent it from providing constant protection.
288-3272-00
Visit Us on the Web! www.SmokeAlarms.com
11407 Cronhill Drive, Suite A
Owings Mills, Maryland 211 17 USA
©2000 UNIVERSAL SECURITY INSTRUMENTS, INC.
Printed in China