Universal Security Instruments HS-5300 User Manual

OWNER'S MANUAL

PORTABLE MOTION
SENSOR ALARM

BUILT-IN HIGH OUTPUT

105 dB ALARM

VERIFICATION TONE FOR

KEYPAD AND ARM/DISARM

MOTION SENSOR DETECTS MOTION

AND ACTIVA TES ALARM

ADJUSTABLE SENSOR HEAD

PROGRAM AND LOW
BATTERY INDICATOR

ALARM CHIME OPTION

PROGRAMMABLE
SECURITY CODE AND
ENTRY DELAY TIMING

PANIC BUTTON

9 VOLT BA TTERY OPERA TED (NOT

INCLUDED) AND AC ADAPTOR COMPATIBLE

INTRODUCTION

Universal's passive infrared system monitors the area where it is placed
and activates instantly when motion is detected.

In the Entry Chime mode, the chime will sound each time motion is
detected.

HS-5300

IMPORTANT SAFETY TIPS

1. Do not install the alarm where it will be exposed to direct sunlight or rain.

2. The alarm siren is very loud. Never put the product close to your ear.

3. The sensor should be directed away from heat sources such as radiators, heating
ducts and stoves.

4. If the product goes off at random, it may be located too close to a heat source.
Changing the location or direction of the sensor alarm can remedy this.

5. The sensor alarm can provide valuable protection for your home and property if
utilized properly. However, this unit cannot guarantee complete protection against
burglary or robbery. Therefore, the manufacturer will not be held responsible for any
loss or damages which could occur.

INSTALLA TION
Battery (FIG . 1)

1. Remove the screw from the battery compartment cover
and slide it down to remove.

2. Install a 9 Volt Alkaline battery (not included).

3. Replace the battery compartment cover and screw.

Wall Mounting (FIG. 2)

FIG. 1

Using the battery cover as a template, mark the locations
of the holes and install anchors and screws. Place the
sensor alarm over the screws and slide the product down
to secure in place.

The sensor alarm should be mounted between 3 and 6.5
feet (1 to 2 meters) above the floor for best coverage of
the protection area. Adjust the sensor head left or right
for the best direction of detection area.

FIG . 2

Shelf Top Mounting (FIG. 3)

Turn the sensor head clockwise 180 degrees to the back,
then turn the head upwards to the desired angle. Place it
on the shelf top location you selected.

FIG. 3

AC Adaptor (FIG. 4)

Use only a 9 Volt DC 200 mA AC Adaptor (not included)
with a 3.5mm diameter male plug, center positive (+).

PROGRAMMING

FIG. 4

NOTE: When you first install the battery, the initial security code set by the factory is

"0-0-0." You can program your own security code (up to 6 digits). If more than
6 digits are entered, you will hear an error tone.

1. To change an existing code to a new code:
a. Enter the old code number (0-0-0 is factory preset).
b. Press the "PROG" button.
c. Enter your new security code (1 to 6 digits).
d. Press the "PROG" button again.