Universal Remote Contorl UR2 211 Operating Manual
Operating
Manual
For Easy
Clicker
U
R
2
›
2
1
1
Universal Remote Control, Inc.
www.universalremote.com
OCE›0082E Rev 02 (02/14/12)
Introduction
1
This remote control is designed to
operate most Digital, Analog Cable
boxes, IPTV set top boxes and TVs.
Button Functions
2
Replacing Batteries
3
Before you program or operate the remote
control, you must install two new AA
alkaline batteries.
STEP1 Remove the battery compartment cover
from the back of your remote control.
STEP2 Check battery polarity carefully,
and install the batteries as shown
in the illustration below.
STEP3
Replace the battery
compartment cover.
Programming the Remote Control
4
*Note : In this section, when you are instructed to press a [DEVICE] button, that means you should press either the
CBL or TV button, depending on which device you are programming the remote to operate.
A. Quick Set!Up Method
A. Quick Set!Up Method
(Refer to the Section 5 Quick Set!up table of codes)
STEP1 Turn on the equipment you want to program. To program your TV, turn on the TV.
Loading...