Universal Furniture Explore Home 071160, REPRISE TALL CABINET Assembly Instructions Manual

Page 1of 2

ASSEMBLY INSTRUCTIONS 071160 Tall Cabinet

Thank you for purchasing this quality product. Be sure check all packing material carefully for small parts that may
have come

loose inside the carton during shipment.

Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the assistance of
one or more

persons in order to prevent personal injury and to insure parts are not damaged during the assembly

process. If dirty, clean

finished parts with mild dishwashing liquid and water solution applied on damp cloth. Cloth

should not be excessively wet.
Polish finish with soft cloth and an industry recognized furniture polish.

(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for stain

residue and rough

surfaces and also check for staples or nails left after removing the packaging material. The

manufacturer will not be held

responsible if preventative steps are not taken prior to installation.

(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or

hardware. Read the

instruction sheet and parts list carefully. Remove all staples and screws used for

packaging carefully using pliers and or

screwdrivers to prevent injury and scratching or damaging flooring.

(4) During normal use every day, screws, bolts, nuts and wooden plugs may loosen up. They should be

periodically inspected

and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to the
furniture proper1y and kept tightened at all times.

Step

1:

The case leveler system is designed to use when leveling the case to insure that the doors open and

close

properly in the event of an uneven floor. To adjust, simply tilt case back and screw leveler in or out to

the necessary

position.

Step 1

Page 2of 2

Step 2: The adjustable shelves are pre-fixed by vender, but can be adjusted and removed. Remove the
screws from the bottom of the shelf. Install the shelf support into desired height holes, put the shelf on the
shelf support.

Assembly is now complete.

Step 2