Universal Furniture Explore Home 071040, Explore Home 07106M, REPRISE DRESSER, REPRISE STORAGE MIRROR Assembly Instructions Manual

Page 1 of 2

ASSEMBLY INSTRUCTIONS 071040 Dresser & 07106M Vertical Storage Mirror

Thank you for purchasing this quality product. Be sure check all packing material carefully for small parts that
may have come loose inside the carton during shipment.

Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more

persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet.

Polish finish with soft cloth and an industry recognized furniture polish.

(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for stain

residue and rough

surfaces and also check for staples or nails left after removing the packaging material.

The manufacturer will not be held responsible if preventative steps are not taken prior to installation.

(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or

hardware. Read the

instruction sheet and parts list carefully. Remove all staples and screws used for

packaging carefully using pliers and or

screwdrivers to prevent injury and scratching or damaging
flooring.
(4) During normal use every day, screws, bolts, nuts and wooden plugs may loosen up. They should be

periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.

Note: Lay out all the parts and hardware to make sure the quantity of each is correct.

Page 2 of 2

Step

1:Stick the adhesive felt pad (5J on the bottom side of mirror (BJ before lifting

it

to the dresser (AJ as
shown. Carefully lift the mirror (BJ onto the dresser (AJ. Attach the mirror (BJ to the dresser (AJ by
screwing through the

mirror support (CJ into the dresser and mirror frame, using flat washers (1J, spring
washers (2J and bolts (3J. Tighten by hand at first, securely tighten by Allen wrench (4J, but do not over
tighten the bolts. Adjust the levelers on the bottom of dresser if necessary.

Assembly is now complete.