Universal Flow Monitors (UFM) CPM Operating Manual

1

CPM manual

Vortex Shedding Water Add Flowmeter

PROPRIETARY NOTICE

The information contained in this publication is derived in part from proprietary and
patented data. This information has been prepared for the express purpose of assisting in
installation, operation, and maintenance of the instruments described herein. Publication
of this information does not convey any rights of use or reproduction other than in
connection with the installation, operation and maintenance of the equipment described
herein. Universal Flow Monitors, Inc. reserves the right to change the information
contained in this publication at any time and without prior notice.

Install in pipe making sure to orient IN port to flow supply.

10 pipe diameters distance is required upstream and 5 down for best accuracy.

Use proportional spacing if this much space is not available.

50 pipe diameters are required upstream as distance from a valve.

No use of Teflon tape please. (See detailed piping instructions.)

Attach cable assembly using grease (included) for added sealing around pins.

STARTUP FOR UNITS WITHOUT DISPLAY (PART NUMBER 73702)

QUICK SETUP

PIPING

There are no additional steps beyond piping and wiring.

STARTUP WITH DISPLAY UNITS (PART NUMBER 78223)

Setup

At startup, digital display of 8.8.8 to show that all segments are present 8.8.8.
Display shows that it is a totalizing unit. Tot
Firmware version displayed. 4.66
Gallons/liters are the engineering units. G-L
Total is shown at zero (unless the total was saved). 00.0

Resetting total

Push “Set” button to reset the total to zero. 00.0

Changing from Gallons to Liters

There are two buttons. “Menu” and “Set”.
Menu changes the readings from Gallons to liters and back again.

If set to liters, there is an added decimal at the end 32.3.
If set for gallons, no added decimal point. 8.53

2