Universal Fibre Optics MICSL DMX User Manual

MicroLED Light Source Range

Models covered by this manual:

UFO MICSL DMX

Please read this manual fully before installing, operating or performing

maintenance on the light source unit.

Light Source User Guide

Issue 4 | Revised: 260418

Universal Fibre Optics

Home Place | Coldstream | TD12 4DT | United Kingdom
Tel: [phone] | Fax: [phone]

www.fibreopticlighting.com

MicroLED Light Source Range

INTRODUCTION

Thank you for purchasing this UFO Light source.

Please read these instructions fully before connecting your unit to the electrical supply, and keep them
for future reference.

The UFO MicroLED range of light sources utilises an RGBW LED array and is suitable for use with either
glass or polymer fibre-optic harness

This MicroLED is powered by a 100-240VAC PSU or LED Driver.

IMPORTANT

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

2

TYPE Y ATTACHMENT: If the external flexible cable or cord of this luminaire or
associated PSU/driver is damaged. It shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person to avoid a hazard.

LOCATION: Do not locate this luminaire closer than 200mm from any flammable
surface.

CLEARANCE/VENTILATION: It is imperative that a gap of 200mm is le around the
unit. This is to allow air to circulate and prevent overheating. The location must
have free ventilation and must not have a ambient temperature higher than that
specified for the luminaire.

MOUNTING: This is a fixed luminaire. See separate mounting plate instructions for
fixing to surface.

WARNING: Never look directly into the Luminaire LED light source.

IMPORTANT: The luminaire should be positioned so that prolonged staring into the
luminaire at a distance closer than 0.33 m is not expected.

Universal Fibre Optics

3

INSTALLATION INSTRUCTIONS

POWER SUPPLY REQUIREMENTS

This luminaire is powered by a 12V Power Supply Unit or 12V Constant Voltage Driver. Remove the
PSU/driver from its box. The driver caters for UK/European/other mains supplies using the relevant
power cord supplied.

Connect the jack plug into the socket in the back, and the light source is now ready for connection

.

MicroLED Light Source Range

4

MOUNTING

If using the metal mounting plate proceed as follows:

STEP 1
Remove the rubber feet from the bottom of the Light Source

STEP 2
Push fit three of the expansion fittings into the holes vacated by the feet as shown –
DO NOT fit an expansion fitting into the foot hole at the rear below the push buttons

STEP 3
Place the mounting plate on the base as shown and push the remaining expansion
fitting through the plate into the hole that does not have one fitted. Fit all four
screws and tighten. Do not over tighten

The luminaire can now be fixed securely to the mounting surface.