Universal Electronics 2001 User Manual

REMOTE USER GUIDE

Safety Instructions

You must keep safety in mind while using this device. Keep these and
any other instructions for future reference.
Observe Warnings: Carefully follow all warnings on the device and in
the operating instructions.
Heat: Do NOT place the device near heat sources such as radiators,
stoves, heat registers, or other appliances that produce heat.

Care and Use

Cleaning: Do NOT use liquid, abrasive, solvent, or aerosol cleaners.
Use a damp cloth for cleaning.

When Not in Use: Remove the batteries if this device is to be le

unattended or unused for a long period of time.

Refer servicing to qualied personnel when a solid

object or liquid has fallen onto or into the device.

Do NOT attempt to service this device. Refer all

servicing to qualied personnel. Opening covers other

than the battery cover will void the warranty.

Publishing Information

Copyright © 2015. EchoStar Technologies L.L.C., Englewood, Colorado

80112. All rights reserved.
The information in this User Guide may change without notice.
Revisions may be issued to tell you about such changes.

Send comments or questions about this User Guide to
[e-mail] or
Technical Publications, EchoStar Technologies L.L.C,
90 Inverness Circle East, Englewood, Colorado 80112.

Document Number: 204884
Printed in

All product names, trade names, or corporate names mentioned in
this User Guide are acknowledged to be the proprietary property of
the registered owners.

INSERT THE BATTERIES

Slide the remote battery

1

2

cover o.

Insert two (2) AA
batteries, making sure to
match the plus (+) ends
with the plus markings
on the battery case
(opposite each other).

3

Replace the remote
battery cover.

1

PAIRING AND UNPAIRING THE
REMOTE

To Pair the Remote

For the remote to work with the SAGE receiver, it must
be paired. Use the following procedure to pair the
remote.

Press the RESET button on

1

SAGE’s back panel.

2

To Unpair the Remote

To unpair a remote from the SAGE receiver, press
and hold the THERMOSTAT and BACK buttons

simultaneously for 13 seconds. SAGE conrms unpairing

is successful.

On SAGE’s remote, press
the CAMERA and LIGHTS
buttons simultaneously.

SAGE conrms pairing is

successful.

Sec.

2