Unitronics Jazz OPLC JZ20-R10, Jazz OPLC JZ20-J-R10, Jazz OPLC JZ20-J-R16, Jazz OPLC JZ20-R16 Installation Manual

Unitronics 1

Jazz OPLC ™

Micro-OPLC Installation Guide

JZ20-R10/JZ20-J-R10

JZ20-R16/JZ20-J-R16

6 Digital Inputs, 4 Relay Outputs

6 Digital, 2 Analog/Digital, 2 Analog Inputs, 6 Relay Outputs

 Before using this product, the user must read and understand this document.
 For additional information regarding this product, refer to the user guide and technical specifications.
 All examples and diagrams are intended to aid understanding, and do not guarantee operation.

Unitronics accepts no responsibility for actual use of this product based on these examples.

 Please dispose of this product according to local and national standards and regulations.
 Only qualified service personnel should open this device or carry out repairs.

Failure to comply with appropriate safety guidelines can cause severe injury or property damage.

 Do not attempt to use this device with parameters that exceed permissible levels.
 To avoid damaging the system, do not connect/disconnect the device when power is on.

Environmental Considerations

 Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,

moisture or rain, excessive heat, regular impact shocks or excessive vibration.

 Ventilation: 10mm space required between the OPLCs’ top/bottom edges & enclosure walls.
 Do not place in water or let water leak onto the unit.
 Do not allow debris to fall inside the unit during installation.

Mounting

Dimensions

* Note that for JZ20-J modules those dimensions are 7.5 mm (0.295”).

03/14

JZ20-R1X/JZ20-J-R1X

2 Unitronics

Add-on modules-

Available by separate order for

communication and cloning.

Integral USB Port

This may be used for

programming purposes.

Note:

the USB port and an Add-on module cannot be physically connected at the same time.

Add-on: during installation

Add-on: after installation

USB Port

Installing an Add-on module requires sufficient clearance space

72 mm (2.835")

27.5 mm
(1.083")

38 mm

(1.496")

35.8 mm

(1.409")

DIN-rail mounting

Snap PLC onto the DIN rail

Panel mounting

Cut-out: 117 x 89mm
(WxH)(4.606”x 3.504”)

Notes: Removing the unit requires clearance space. Recommendation: approximately 40mm (1.58”)

For UL listed module, in order to meet the UL508 standard, panel-mount this device on

the flat surface of a Type 1 enclosure.

Wiring

 This equipment is designed to operate only in SELV/PELV/Class 2/Limited Power

environments.

 All power supplies in the system must include double insulation. Power supply outputs

must be rated as SELV/PELV/Class 2/Limited Power.

 Do not connect either the ‘Neutral or ‘Line’ signal of the 110/220VAC to device’s 0V pin.
 Do not touch live wires.

 All wiring activities should be performed while power is OFF.
 Install an external circuit breaker. Guard against short-circuiting in external wiring.
 Use appropriate circuit protection devices.
 Unused pins should not be connected. Ignoring this directive may damage the device.
 Double-check all wiring before turning on the power supply.

Caution

 To avoid damaging the wire, use a maximum torque of 0.5 N·m (5 kgf·cm).
 Do not use tin, solder, or any substance on stripped wire that might cause the wire

strand to break.

 Install at maximum distance from high-voltage cables and power equipment.