United States Stove Company 1864 User Manual
Owners ManualOwners Manual
Owners Manual
Owners ManualOwners Manual
18641864
1864
18641864
Hasty Baker RangeHasty Baker Range
Hasty Baker Range
Hasty Baker RangeHasty Baker Range
CAUTION!
Read All Instructions Carefully Before Starting The Installation or Operating This
Stove.
SAVE THIS MANUAL FOR FUTURE REFERENCE
THIS MANUAL WILL HELP YOU TO OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM THE HEATER, AND ENABLE
YOU TO ORDER REPAIR PARTS CORRECTLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
UNITED STATES STOVE COMPANY
227 Industrial Park Road
P.O. Box 151
South Pittsburg, TN 37380
(423) 837-2100
I
N
U
U
T
A
E
T
S
S
D
E
T
S
C
O
M
S
N
A
P
S
T
C
Y
O
V
E
U.L. LISTED COAL BURNING STOVE
IN A MOBILE HOME OR TRAILER
NOTE: THIS IS NOT A
DO NOT USE THIS HEATER
Keeping America Warm
since 1869
851500
Illustrations
21-1/2"
STOVE DIMENSIONS
FIGURE 1.
34-3/4"
30"
(SIDE VIEW)
17-3/4"
FLOOR
PROTECTOR
(FRONT VIEW)
28"
Specifications
Height (Overall)...................................... 30 " Material............................................ 100% Cast Iron
Width...................................................... 34.75" Fuel.................................................... Coal or Wood
Depth...................................................... 21.5" Weight......................................................... 313 lbs.
Firebox Depth......................................... 15 "
Flue Size (Round).................................... 6"
Door Opening......................................... 13" x 10
Instructions for Warming Oven Attachment
1. Align the cast iron warming oven brackets (small end down,
holes to the inside) with the edge of the stove top, ensuring that
the bracket corners are lined up with the corresponding back
corners of the stove top. It is easier to work with one bracket at
a time.
2. Once the bracket is aligned, mark through the holes (one per
bracket) on to the top of the stove using a sharp scribe. You may
have to estimate the center of the hole, but it doesn't have to be
exact.
3. Remove the bracket(s).
4. Locate and mark the center of the hole with a sharp center
punch to prevent the drill from wandering when drilling.
5. Use a variable speed drill motor with a 1/4" drill bit. Drill the
holes at a LOW SPEED setting, using light pressure, straight
through the stove top.
6. Complete the assembly of the warming oven as follows:
- Fasten the brackets to the stove shop
- Install the warming oven on the brackets
- Install the back splash shield between the stove
and the warming oven. The lip on the splash shield
should be at the bottom facing the front of the stove.
- Install the top piece on the warming oven.
29-1/2"
25"
61-1/2"
7. Installation should now be completed.
2
CONGRATULATIONS!
You have purchased the Hasty Baker Range from North America's oldest manufacturer of wood and coal burning
products. Our Hasty Baker Range is an endeared classic that is still used daily in many parts of our country. Our
range is fully functional and its large firebox with shaker grate allows stove to burn both wood and coal. Convenient
ash drawer makes cleaning out ashes easy. An Optional Warming Oven is available. Stove comes pre-assembled
except for legs and base.
Wood is our only Renewable Energy Resource. Please do your part to preserve our wood supply. Plant at least
one tree each year. Future generations will thank you.
Safety Rules
SAFETY NOTICE: If this heater is not properly installed a house, fire may result. For your safety, follow the
installation directions. Contact local building or fire officials about restrictions and installation inspection
requirements in your area.
Read these rules and the instructions carefully.
1. The installation of this stove must comply with your local building code rulings. Please observe the clearances to
combustibles. (Refer to Figures 1 and 2) Stove must be 36" from a combustible wall (wood or plaster board) at
rear or sides.
2. DO NOT install this stove in a mobile home or trailer.
3. Always connect the stove to a chimney and vent to the outside. Never vent to another room or inside a building.
4. DO NOT connect a wood burning to an aluminum Type B gas vent. This is not safe and prohibited by the NFPA
(National Fire Protection Agency) This stove requires approved masonry or a UL 103 HT Listed Residential Type
and Building Heating Appliance Chimney. Use a 6" diameter chimney or larger, that is high enough to give a good
draft.
5. Be sure that your chimney is safely constructed and in good repair. Have the chimney inspected by the fire
department or a qualified inspector. Your insurance company may be able to recommend a qualified inspector.
6. Creosote or soot may build up in the chimney connector and chimney and can cause a house/building fire. Inspect
the chimney connector and chimney twice monthly during the heating season and clean as necessary. (See
Chimney Maintenance, page 6)
7. Provide air for proper combustion from outside the house into the room where the stove is located. If the intake is
not in the same room, air must have free access to the room.
8. To prevent injury, do not allow anyone to use this stove who unfamiliar with the correct operation of the stove.
9. For further information on using your stove safely, obtain a copy of the National Fire Protection Association publication "Using Coal and Wood Stoves Safely" NFPA No. HS-10-1976. The address of the NFPA is Batterymarch Park,
MA, 02269.
10. Dispose of the ashes in a metal container with a tight fitting lid. Keep the closed container on a non-combustible
floor or on the ground, well away from all combustible materials. Keep the ashes in the closed container until all
cinders have thoroughly cooled. The ashes may be buried in the ground or picked up by a refuse collector.
11. The special paints used on this stove may give off some smoke and an odor while they are curing during the first
few fires. Paint discoloration will occur if the stove is overfired.
12. This stove has a painted surface which is durable but it will not stand rough handling or abuse. When installing
your
stove, please handle with care. Clean with soap and warm water when stove is not hot. Do not use any acids or
scouring soap, as the will wear and dull the finish.
13. While the stove is in operation, all persons, young children especially, should be alerted to the hazards from high
surface temperatures and should keep away to avoid burns or clothing ignition. Small children should be carefully
supervised when they are in the same room with the stove.
14. Keep stove area clear and free of all combustible materials such as gasoline and/or other flammable vapors and
liquids
3
Loading...