United Security Products PA-4 User Manual

Patient Alert

Follow these simple instructions to set up
your system

PA- 4

BED

Fall PreventionSystem

QUICK START GUIDE

Step 2.Connect the cord.

Place the connector plug on the end of
the pad into the socket on top of the
Patient Alert unit as shown.

Step 1. Positioning the Pad.

Place the sensor pad on the Bed ­underneath mattress cover or bottom
sheet with the cord placed unobtrusive
and routed to Patient Alert unit.

Step 3. Position the Alert Unit.

With the Patient Alert still in the off position,
attach the Alert unit to desired location on bed
using the Mesh Bag provided. Patient Alert
sound is designed to alert caretaker while

*IMPORTANT
If Patient Alert System Fails ­Replace Battery.
Replace Battery Periodically

Test System Before Each Use

alerting patient to return to bed.

Step 4. Operate the system.

Place the patient on the bed. Now you are

ready to activate the Patient Alert unit.

A- Momentary Activation ( MOM)

Switch Alert unit to MOM position. This will
activate Alarm when patient attempts exit. The
Patient Alert unit will Automatically reset and
silence alarm when patient returns to Sensor
Pad position or unit is turned off by caretaker.

B- Continuous Activation ( CONT)

When the Alert switch is placed in CONT posi­tion and patient exits Sensor Pad, Patient Alert
will sound alarm continuously until turned off by
caretaker

PLEASE SEE REVERSE SIDE FOR
LIFETIME SENSOR PAD
INSTALLATION INSTRUCTIONS

LIFETIME SENSOR PAD MOUNTING INSTRUCTIONS

PLEASE READ

WHEELCHAIR OR CHAIR

INSTALLATION

Mount Sensor Pad ACROSS
Wheel Chair Seat with wire leads
routed toward back to Patient
Alert, sensor units or transmitter.

CAREFULLY

BED

INSTALLATION

Mount Sensor Pad ACROSS Bed with wire leads
routed toward back to sensor unit.
Mount at patient HIP position on bed for normal
response time use.
Mount at beneath shoulders position for Quick
Response. Sensor Pad may be placed beneath
bed cover or bottom sheet.

DO NOT! MOUNT SENSOR PADS AS SHOWN BELOW !

DAMAGE WILL OCCUR TO SENSOR PADS AND VOID LIFETIME WARRANTY.

DO NOT MOUNT SENSOR

PAD LENGTHWISE ON
WHEELCHAIR OR BED.
THIS WILL BEND SENSORS

INSIDE PAD AND VOID

LIFETIME WARRANTY

DO NOT FOLD, BEND OR ROLL SENSOR PAD

* ( This will Void Lifetime Warranty)

IMPORTANT WARRANTY INFORMATION

Do Not Return Defective Sensor Pads to Distributor!

If you believe Sensor Pad is defective, Call 1-800-227-2474

To speak with Customer Service Tech and receive Return Authorization Number