United Security Products AD2000, AD2000-W, AD2001, AD2001-S, AD2001-W Quick Start Guide

United Security Products, Inc. Tele:800-227-1592

10801 Vista Sorrento Parkway Fax:[phone]
San Diego, Ca. 92121

Automatic Voice Dialers

AD2000 and AD2001

Quick Start Guide

This Quick Reference Guide provides directions for FAST START
installation, setup and programming of your innovative alarm sys­tem. It also serves as a handy reference.

NOTE: Have the program planner, found in the manual in front
of you ready to be filled in. Plug in Main Phone line to the “Tel­In” port on dialer. Connect a 12Vdc power supply with a mini­mum rating of 100mA from an existing alarm panel or an exter­nal power source to the indicated terminal blocks.

Overview

When you apply power to the unit, you will see an identification for the unit
you acquired followed by the first option- Program Numbers. There are
essentially four main menus for the dialer-Program Numbers, Program T­Line, Program OGM’s (outgoing messages), and Program Channels. There
are three operating conditions-OFF, Operate and Test T-line.

Step 1. Program: Numbers 1(Yes) 2(No)--Press 1

Depending on model you have option to select 4 or 8 telephone numbers or
pager numbers for outgoing messages. These are the numbers you might
want to have the dialer call in case of alarm. Remember there are two
(AD2001) or four (AD2000) alarm channels. You do not have to call all the
numbers for each alarm. You may want to call one for each or two for each
etc.. For this example press 1 for Program Numbers and select 1 for the first
telephone number. Pager - press 2 for No.(See manual for entering pager
numbers.) Enter the number with no dashes or spaces and press the star key.
When done entering numbers press 0 for done at the prompt after entering
the last number.

Step 2. Program: T-Line 1(Yes) 2(No)--Press 1

PROGRAM:T-LINE
1 (Tone) 2 (Pulse)

PROGRAM:PBX
1(ON) 2(OFF)

PROGRAM:ATTEMPTS
ENTER 1-9

PROGRAM: MESSAGE
REPEAT ENTER 1-3

PRESS 1 FOR TOUCH TONE PHONES.

PRESS 2 OFF. (See Manual for PBX)

How many times do you want the telephone or
pager to be dialed for successful connection.

Refers to the number of times each message
will be delivered to each designated number.

Step 3. Program: OGMS 1(Yes) 2(No)--Press 1

OPT#1: NO OGM
1 (YES) 2 (NO)

Yes to this option no message will be deliv­ered. To have a message, Press 2.

OPT#2: 1OGM
1 (YES) 2 (NO)

For only one message to be delivered for each
alarm Press 1. For several messages, say one
for channel 1 and one for channel 2, Press 2.