UNITED USF-654 Instruction Manual

16”Metal Stand Fan With Remote Control

MODEL: USF-654

SAFETY PRECAUTIONS

When using any electrical appliance, basic safety precautions should always be followed, including the

following:

1. Read all instructions and keep for future reference.

2. This appliance is not intended for use by persons (including children) with reduced physical,

1

sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.

3. Young children should be supervised to ensure that they do not play with the appliance.

4. Always unplug the appliance from the mains when not in use.

5. To disconnect the appliance, switch the control to OFF, then unplug from the mains.

6. To unplug the appliance, always grasp the plug; do not pull the cord.

7. If the supply cord is damaged it must be replaced by the manufacturer, its service agent or a
similarly qualified person in order to avoid a hazard.

8. Do not use outdoors. This appliance is designed for household use only.

9. Place the power cable away from areas where people walk so that it cannot be stepped on or
tripped over.

10. Always use the appliance on a flat, stable surface.

11. Never clean this appliance when it is plugged in .Do not immerse it in water, Clean the outside
surface with a damp cloth or soft brush and dry with a soft dry cloth.

12. Use the appliance only as directed in this manual. Misuse could void your warranty.

13. Avoid contact with moving parts, never insert any objects through the grille when the fan is in
operation.

ASSEMBLY INSTRUCTIONS:

Base Assembly

1. Unscrew the Ring and

Base Locking Screw from the
Stand Assembly.

2. Insert the Stand Assembly through

the hole in the center of the Stand Base
and twist into position.

3. Turn the Stand Base upside down with

the Stand Assembly facing the floor
and place the Base Weight Support to
the bottom of the Base.
Tighten the Base Weight Support
to the Stand Base by screwing back
the Ring and Base Locking Screw

Stand
Assembly