UNITED USF-622, USF-630 Instruction Manual

INSTRUCTIONS MANUAL
MODEL: USF-622
16” Stand Fan
Thank you for your purchasing this fan. Please read all instructions carefully and keep for future use.
Please read these Operating Instructions through carefully before connecting your device to the mains, in order to avoid damage due to incorrect use. Please pay particular attention to the safety information. If you pass the device on to a third party, these Operating Instructions must also be handed over.
STRUCTURE
1. FRONT GUARD
2. FAN BLADES
3. GUARD MOUNTING NUT
4. BACK GUARD
5. MOTOR SHAFT
6. MOTOR HOUSING/SWING BUTTON
7. SWITCHES
8. SWITCH COMPARTMENT
9. LOCK SPRAIN
10. UPPER TUBE
11. TUBE CONNECTOR
12. LOWER TUBE
13. ROUND BASE
SPECIFICATIONS
VOLTAGE
FREQUENCY
POWER
220-240V~
50Hz
50W
ASSEMBLY
1. Secure lower tube with tube support to the hub of Round Base with screw provided.
2. Extend upper tube, insert the tube connector through upper pipe onto lower tube and tighten.
3. Attach the motor with switch compartment onto the upper tube. Ensure the switch compartment
is pushed fully onto the upper tube and secured with the screw provided.
4. Loosen Guard Mounting Nut from the Motor Housing.
5. Position Back Guard firmly to Motor Housing and then fasten by turning Guard Mounting Nut
clockwise tightly.
6. Push the Blade along Motor Shaft. Fasten it firmly with Spinner by turning counter clockwise.
7. Place the front grille securely on top of the back grille and lock in place using the securing clips.
OPERATION CONTROL
Before using the fan, make sure that it is on a flat and stable surface. Damage may occur if the
fan is placed on an incline.
Insert the plug directly into a standard AC socket-outlet. Be sure that the plug fits tightly into the
socket-outlet.
How to operate the fan
On: Press the speed button of your selection to turn on the fan. Press 1 to get the low speed, press 2 to get middle speed, press 3 to get high speed. Off: Press 0 button to turn off the fan. Swing: Press the button found on the motor housing to start the oscillation of the fan
CAUTION
Do not use this appliance near water. Do not use this appliance near bathtubs, showers, basins or other vessels containing water. Never immerse the motor unit, cord and plug into water If the appliance fell down into water, unplug it immediately, then take it out and bring it to
authorized Service Center for checking
Never use the appliance with wet hands Never use the appliance on a damp floor Never use the appliance with an extension lead Never use the appliance with the damaged wall outlet Any examination, repair or adjustment must be done in an authorized Service Center. Do not repair the appliance by yourself! If the opening of the appliance is detected, the
appliance's guarantee will be canceled.
Never use the appliance near or on the hot surfaces Never let the cord hang over the edge of the table or touch any hot surfaces Always unplug the appliance when not in use/before cleaning Do not let children play or use the appliance Give a high attention when the appliance is being used near the children
Loading...
+ 1 hidden pages