UNITED UCH-869, UHQ-857 Instruction Manual

INSTRUCTION MANUAL

FOR CARBON HEATER

UCH-869

Read these instructions carefully and keep them for

future reference

DESCRIPTION

Voltage: 220~240V
Frequency:50/60Hz
Two heating power:1100W/2200W
Carbon heating element
With thermostat protection
Tip-over switch protection

ASSEMBLY

1. Carefully turn the appliance upside down to fit the castors.

2. Slide the wheel plate at the right position.

3. Secure the wheel plate by lightening the butterfly nut.

4. Put the appliance in the upright position.

5. Take out the cable from the cable bracket backside.

OPERATION

1. Switch the heater to one of the following power settings:

 I – low heating power;
 II – high heating power;

NOTE!
This device will cool slowly after the power is shut off. Allow the heater to cool prior to
any movement. The built-in carry handle should be used for easy movement.
When this device is overheated it is automatically turned off by a special security
system. Unplug the device and let it cool down before activating it again.

2. Once you finished using the heater, turn the power switches to the “OFF” position,
then unplug the main power supply.

CLEANING

1. If not used for a long time, clean the heater’s surface and keep it in the original

packing. Keep the heater in airy place and pay attention to avoid dampness.

2. Use a damp cloth to clean the surface of appliance, avoid water going inside the

appliance, and dry the appliance before use or store.