UNITED UBF-655 Instruction Manual

INSTRUCTIONS MANUAL

MODEL: UBF-655

12” Box Fan

Thank you for your purchasing this fan. Please read all instructions carefully and
keep for future use.

Please read these Operating Instructions through carefully before connecting your
device to the mains, in order to avoid damage due to incorrect use. Please pay
particular attention to the safety information. If you pass the device on to a third party,
these Operating Instructions must also be handed over.

How to operate the fan

IMPORTANT:

REMOTE CONTROL

The Remote Control requires 2 AAA batteries (not supplied) for operation.
To install the batteries, simply depress the back of the remote, with your thumb in the indentations,
and remove the cover. Insert the batteries according to the diagram shown inside. Replace the cover.

Operating

1. Set the fan on a dry level surface.

2. Plug the cord into a suitable 220-240V AC outlet.

3. Turn the fan on by pressing the Speed button – I II III – on the remote control or on the control

panel. (see fig. 1/2). The appropriate LED light on the front of the fan will illuminate. Turn the fan
Off by pressing the OFF button. Pressing the OFF button will automatically clear all settings and
reset the fan.

4. The speed is adjusted by repeatedly pressing the Speed button – I II III – on the remote control

or on the control panel.
I = Low speed II = Medium speed III = High speed
The appropriate LED light on the front of the fan will illuminate.

ADJUSTMENT

Oscillation control (see fig. 1/2)
To start and stop oscillation of the wind wheel, push the Oscillation button on the remote
control or on the control panel.

Timer control (see fig. 1/2)
To start and stop the timer, press the Timer button on the remote control or control panel to
cycle through the timer settings.
The appropriate LED light on the front of the fan will illuminate.

Natural breeze movement / Sleep control (see fig. 1/2)

1. For a natural breeze movement, push the Breeze button once. This will automatically vary

the fan speeds faster and slower.

2. Push the button again to activate the sleep control. This function slows the fan speed

down and when used in conjunction with the timer settings will gradually slow the fan down and
switch off. e.g. SLEEP + 4hrs TIMER programs the fan to gradually slow down over the 4 hours and
eventually turn off.

3. Push the button a 3d time to switch off the BREEZE and SLEEP functions.

The appropriate LED light on the front of the fan will illuminate when the Breeze function is selected.

Fig 2
Fig1 Fig 1