Page 1
Reading Mode
MS280
CCD Barcode Scanner
Quick Start Guide
Connecting the Scanner
Connect USB cable to the USB port of a host PC.
Continuous Mode
LED is always on.
The trigger does not function in
Continuous Mode.
Toggle Mode
The LED is always on when the trigger
is pressed.
The LED will go o if one bar code is read.
Factory Default
Write to
Custom Defaults
Flash Mode
The LED is on steady if a bar code is
close to the scanner, but starts ashing
if no bar code is detected after 60
seconds.
The trigger does not function in Flash
Mode.
Prefix and Suffix
Clear pre/ postamble
Preamble
Trigger Mode*
The LED will light when the trigger is
pressed.
The LED will go o when the trigger is
released.
Test Mode
Factory Scanability Test Use Only
Example:
Set PREAMBLE String as “ ## ”
POSTAMBLE String as “ $$ ”
Setting Procedure:
Step 1 : Scan : CLEAR PRE/ POSTAMBLE.
Step 2 : Scan : PREAMBLE.
Postamble
Step 3 : Scan : “ # ” twice from FULL ASCII Table.
Step 4 : Scan : PREAMBLE.
Step 5 : Scan : POSTAMBLE.
Step 6 : Scan : “ $ ” twice from FULL ASCII Table.
Step 7 : Scan : POSTAMBLE.
*Please download user’s manual from unitech website for FULL ASCII Table.
Data Format:
[Preamble] [Symbology ID] [Barcode Length] [Barcode Data] [Postamble] [Terminator]
Continuous Auto Off
The LED is always on when the trigger
is pressed.
The LED will go o if no bar code has
been detected after 60 seconds.
Notes:
1. A PREAMBLE is a string of up to
16 characters added to the beginning
of a scanned barcode.
2. A POSTAMBLE is a string of up to
16 characters added to the end of a
scanned barcode.
3. Default value for both: None.
Keyboard Layout
US English*
Spanish
German
Hungarian (Qwertz)
Japanese (106 Key)
UK English
Italian
Swiss (German)
Slovak French
Swedish Brazilian ( Portuguese )
Danish
Belgian
Hungarian (101 key)
Portuguese
Swiss (French)
Norwegian
ALT Code
Dutch
Canadian (French)
Canadian (Traditional)
* ：Default Option
For more detailed scanner setting, please go to www.ute.com to download the user manual and the
CZECH (Qwertz)
CZECH (Qwerty)
scanner configuration manager utility.
Version 1.0
401371G
Page 2
MS280
CCD Barcode Scanner
Quick Start Guide
Beep Tone
Beep High
Beep Medium*
Terminator
Send Data Length
Beep Off
Send Data Length On
Beep Low
Send Data Length Off *
CR+LF*
None
TAB
LF
Space
CR*
ESC
Beeper Volume Control
High*
Medium
Note:
Below is the position of Terminator among output data string:
[Preamble] [Symbology ID] [Barcode Length] [Barcode Data] [Postamble] [Terminator]
By default, with Preamble, Postamble, Barcode Length and Symbology ID
disabled, the scanner data output will be:
[Barcode Data] [Terminator]
1. For the USB interface the default terminator is CR.
2. For the RS232 interface the default terminator is CR+LF.
Low
Check Version
* ：Default Option
For more detailed scanner setting, please go to www.ute.com to download the user manual and the
scanner configuration manager utility.
Version 1.0
401371G
Loading...