Unitech MR055 Ethernet, MR350 Setup Manual

Ethernet Setup

Software needed:

Network Enabler Administrator v2.6

http://www.ute.com/files/software/38_NetworkEnabler.zip

OnlineCom Manager (or OnlineDll.dll)

http://www.ute.com/files/software/20_OnlineCommManagerSetup.exe

Connecting the Cradle to your Network:

1. 1. Connect an Ethernet cable to your MR350

2. 2. Run Network Enabler Administrator

Network Enabler Administrator:

.a. Press the scan button to scan for the cradle once it is connected to your

ٛ

network

.b. The Network Enabler Administrator software should see the cradle and

ٛ

the IP address assigned to it. Double click this IP address for a new window

.c. Click on the “Network” tab and modify the IP address to match the IP

ٛ

addresses distributed by your router. In this example, the router distributes

1. 10.0.0.x IP addresses. You can enter the Gateway and a DNS Server
1&2 address.

2. d. Now select the “Serial” tab and check the “Modify” box. Now click
on the settings that appear below. A new window will pop up that will allow
user to change baud rate, parity, data bits, stop bits and flow control. The

3. e. Now select the “Operating Mode” tab and check the “Modify” box.
Make a note of the port, usually 4001. In this case it was changed to 3001.
Once all these steps are completed and updated the user can close the
Network Enabler Administrator application.