Changing your PT630 JobGen Application to an HT630
Application
Your original Unitech PT630 JobGen application will run on the new Unitech
HT630 mobile computer, but minor modifications will have to be made to your
custom application. JobGen will have to launch the Job Engine specifically made
for the HT630. Following the steps below will build the job designed previously
for the PT630 to the HT630, and transfer the correct Job Engine for the HT630.
Instructions:
Open your job (in this case Job1.jgp). On the left hand side of the job, there is a
setting to define the portable model. At default this is “PT630”. Double-Click on
this setting.
Unitech America, Inc Page 1
Change this setting from PT630 to HT630. Select OK
You can now build the job. Select Build > Make Job or press F4
Questions? Contact Unitech at SupportEngineering@ute.com
Unitech America, Inc Page 2
Loading...