Unisteer 8012350-01 User Manual
1965-’67 Ford Galaxie 500 Rack & Pinion Kit Instructions
8012350-01
Full refund will NOT be granted to any kits that are damaged,
scratched, or altered in any fashion.
*USE ONLY POWER STEERING FLUID IN SYSTEM. DO NOT USE ATF.
*ALTHOUGH THIS KIT IS FAIRLY SIMPLE TO INSTALL, SOME MODIFICATIONS
MAY BE NECESSARY.
*BEFORE STARTING INSTALLATION, PLEASE BE AWARE OF THE
MODIFICATIONS THAT ARE NEEDED TO INSTALL.
*DUE TO VARIABLES OUTSIDE OUR CONTROL THESE KITS MAY NOT FIT ALL
APPLICATIONS. ALSO, PLEASE VERIFY KIT WILL FIT YOUR APPLICATION
BEFORE ALTERING VEHICLE.
Page 1 657340
KIT CONTENTS:
#
Part Number
Description
Quantity
1
8012360-01
Rack and Pinion Unit w/bracket
1
2
8021900
Outer Ends
2
3
117840
Inner Ends
2
4
543800
DD Lower Steering Shaft
1
5
620630
Shaft Install Kit
1
6
8060470
C-5 Pump w/ Res. (High Flow)
1
6
8022380
P/S Pump Bracket (Big Block)
1
6
8020630
V-Belt Pulley (Polished)
1
6
156220
Plastic Plug
3
7
8027730
40” Hose Assembly
1
7
8027740
34” Hose Assembly
1
7
8021560
16mm Banjo Fitting
2
8
8050640
U-Joint 17 DD X ¾ DD
1
9
8051410
U-Joint ¾ X 9/16-30
1
10
320010
10ft Header / Exhaust Wrap Kit
1
11
320020
8ft Header / Exhaust Wrap Kit
1
12
205780
Column Bushing Assembly
1
13
200850
5/16” Flat Washers
2
13
230460
1.25 X 25mm Bolts
1
13
208000
3/8” Star Washers
4
14
200840
3/8” Lockwasher
2
14
200860
7/16” Flat Washers
4
14
200030
Flat Washers
3
14
231490
3/8-16 x 1 ½” Hex Bolt
1
14
231660
3/8-16 x ¼” Hex Bolt
1
1 2 3 6 7 5 8 9 13
14
Page 2 657340
Disassembly
The first step is to disassemble and remove the stock steering linkage, steering box and column.
1. Disconnect steering shaft from steering box at rag joint. Raise vehicle and support it on stands.
2. Remove the cotter pins and nuts from outer tie rod ends.
3. Disconnect the center link, power cylinder, idler arm.
Page 3 657340
4. Remove tie rods from spindles.
5. Disconnect the steering lines from the steering box and power steering pump.
Page 4 657340
Loading...