Unisteer 8012290-01 User Manual

1968-’70 Ford Torino Small Block Rack Kit Instructions

8012290-01

Full refund will NOT be granted to any kits that are damaged,

scratched, or altered in any fashion.

*USE ONLY POWER STEERING FLUID IN SYSTEM. DO NOT USE ATF.
*ALTHOUGH THIS KIT IS FAIRLY SIMPLE TO INSTALL, SOME MODIFICATIONS

MAYBE NECESSARY.
*BEFORE STARTING INSTALLATION, PLEASE BE AWARE OF THE

MODIFICATIONS THAT ARE NEEDED TO INSTALL.
*DUE TO VARIABLES OUTSIDE OUR CONTROL THESE KITS MAY NOT FIT ALL

APPLICATIONS. ALSO, PLEASE VERIFY KIT WILL FIT YOUR APPLICATION
BEFORE ALTERING VEHICLE.

Page 1 657220

KIT CONTENTS:

#

Part Number

Description

Quantity

1

8012190-01

Rack and Pinion Unit w/bracket

1

2

8021320

Outer Ends

2

3

320010

10ft Exhaust Header

1

4

320020

8ft Exhaust Header

1

5

8060470

C-5 Pump w/ Res. (High Flow)

1

5

8022490

Pump Belt Tension Bracket

1

5

8022480

Pump Stabilizer Bracket

1

5

8021560

V-Belt Pulley (Polished)

1

5

156220

Plastic Plug

1

6

8027510

48” Hose Assembly

1

6

8027520

56” Hose Assembly

1

6

8021560

16mm Banjo Fitting

1

7

5410550

6.25” DD Shaft (9/16”-30 X Notch)

1

8

545030

Column Insert

1

9

8050640

U-Joint 17 DD X ¾ DD

1

10

8051410

U-Joint ¾ X 9/16-30

1

11

200030

Flat Washers

4

11

230460

1.25 X 25mm Bolts

4

12

622800

Pump Install Kit

1

13

620630

Shaft Install Kit

1

9 8 4 2 6 3 11 7 10

Page 2 657220

Disassembly

The first step is to disassemble and remove the stock steering linkage, steering box and column.

1. Disconnect steering shaft from steering box at rag joint. Raise vehicle and support it on stands.

2. Remove the cotter pins and nuts from outer tie rod ends and remove tie rods from spindles.
Disconnect the center link, power cylinder, idler arm, hoses, and steering box assembly from the
frame and remove the entire old steering linkage system.

Page 3 657220

Page 4 657220

Page 5 657220