Unisteer 8011430 User Manual

1957-1959 Full Size Ford Rack & Pinion Kit Instructions

Part #: 8011400 & 8011430

Full refund will NOT be granted to any kits that are

damaged, scratched, or altered in any fashion.

*USE ONLY POWER STEERING FLUID IN SYSTEM. DO NOT USE ATF.
*ALTHOUGH THIS KIT IS FAIRLY SIMPLE TO INSTALL, SOME

MODIFICATIONS MAYBE NECESSARY.
*BEFORE STARTING INSTALLATION, PLEASE BE AWARE OF THE

MODIFICATIONS THAT ARE NEEDED TO INSTALL.
*DUE TO VARIABLES OUTSIDE OUR CONTROL THESE KITS MAY NOT FIT

ALL APPLICATIONS. ALSO, PLEASE VERIFY KIT WILL FIT YOUR
APPLICATION BEFORE ALTERING VEHICLE.

Page 1 656150

KIT CONTENTS:

#

Part Number

Description

Quantity

1

8011230

Rack and Pinion Unit w/bracket

1

2

231210

Rack and Pinion Install Hardware 3/8-16 x 4.5”

4

2

205790

3/8” Flat Washer

8

2

120490

3/8-16 Lock Nut

4

3

8021250

Outer Tie-Rod Ends

2

4

546190

Column Shaft

1

5

130370

Column Clamp

1

5

206710

Column Bearing

1

5

206730

Column Bushing

1

6

231130

¼” x 14 x ¾” Screws for Floor Plate

8

6

120330

M16 x 2 Wheel Nut

1

7

8025400

Floor Plate Gasket

1

8

8025390

2 Peace Floor Plate

1

9

543360

7 1/8” Long ¾” DD x 9/16-30 Splined Shaft

1

10

8050640

17DD x ¾” DD U-Joint for Rack & Pinion

1

11

8050440

9/16” – 30 Spline x 9/16” –30 Spline U-Joint for Column

1

12

8061020

Power Steering Pump Assembly

1

13

8021310

Pump Line Kit

1

Page 2 656150

1957 – 1959 Full Size Ford Installation Instructions

1. Raise front of car off of ground and place stands under car frame and let suspension hang.
Remove front wheels.

2. From under car, remove the cotter pins and nuts from outer tie rod ends. Remove the idler
arm bolts. Remove the pitman arm from the steering box or remove the joint at the pitman
arm to ease in the removal of the stock box.

3. Remove the steering linkage from the car. If the car has power steering remove the lines from
the assist unit and remove it with the linkage.

Page 3 656150