Unisteer 8010780-02 User Manual
1964-67 CHEVELLE POWER RACK AND PINION KIT
INSTALLATION INSTRUCTION MANUAL
8010780-01 & 8010780-02
Full refund will NOT be granted to any kits that are
damaged, scratched, or altered in any fashion.
Please note that this installation used Hooker 2-1/8” Super Comp Headers.
*USE ONLY POWER STEERING FLUID IN SYSTEM. DO NOT USE ATF.
*ALTHOUGH THIS KIT IS FAIRLY SIMPLE TO INSTALL SOME
MODIFICATIONS ARE NECESSARY TO INSTALL.
*BEFORE STARTING BE AWARE OF THE MODIFICATIONS NEEDED.
*ALSO BE AWARE THAT THERE ARE APPLICATION/PROVISIONS NEEDED
IN ORDER TO INSTALL. PLEASE READ ALL INSTRUCTIONS FIRST.
*DUE TO VARIABLES OUTSIDE OUR CONTROL THESE KITS MAY NOT FIT
ALL APPLICATIONS. ALSO, PLEASE VERIFY THAT KIT WILL FIT YOUR
APPLICATION BEFORE ALTERING VEHICLE.
pg. 1 655680
Kit Contents:
#
Part Number
Description
Quantity
1
8010770-01
Rack & Pinion Assembly
1
1
8060700
Pump Kit
1
2
8021580
Hose Kit w/ Reservoir
1 3 8022270
Shaft Support Bracket
1 4 543790
Upper Shaft
1 5 543800
Lower Shaft
1 6 620630
Shaft Install Kit
1 7 8050760
Shaft Support w/ Nut
1 8 8050250
9/16”-30 x ¾”-DD U-Joint
1 9 8050880
¾”-36 x ¾”-DD U-Joint
1
10
8051410
¾” x 9/16”-30 U-Joint
1
Disassembly:
1. Disconnect negative battery cable before installation.
2. Raise front of vehicle off ground & center & lock steering wheel.
3. Remove front wheels & remove power-steering lines at pump or gearbox.
4. Drain fluid.
5. From under hood, remove pinch bolt at gearbox & shaft union & separate.
pg. 2 655680
6. Remove cotter pins & nuts at outer tie rod ends.
7. Remove two bolts & nuts at passenger side of vehicle attaching idler arm to frame.
8. Remove center link nut from pitman arm at driver side.
9. Separate tie rod ends from spindles & center link from pitman arm & remove steering linkage
from car.
10. Remove three bolts on driver side frame rail that secure gearbox and remove.
pg. 3 655680
Loading...