Unique Appliances UGP-385L CR OWNER’S GUIDE
385L / 14 cu. ft.
SOLAR POWERED
DC FRIDGE
UGP-385L CR
OWNER’S GUIDE
serial number:
JAN 2021
TABLE OF CONTENTS
03 Important safety notes
06 Product features
07 Installation
08 DC power connection
11 Operation
15 Energy saving tips
16 Parts diagram and list
18 Troubleshooting
20 Appliance information
20 Notes
22 Limited warranty
23 Contact us
Congratulations! You have purchased one of the most e cient
refrigeration products available on the market today. The Unique
UGP-385L CR solar powered DC fridge is designed to provide
years of e cient trouble-free operation. The design is optimized
for energy savings with an e cient DC compressor and e cient
insulation.
Before using the appliance, read through this manual carefully
including all the information on safety, installation, operation, and
cleaning. These guidelines do not cover every possible condition or
situation that may occur. Be safe using common sense and caution
when installing, operating and cleaning this appliance. If you are
unsure about any of these instructions or warnings, contact your
local product dealer or Unique Appliances for assistance.
IMPORTANT SAFETY NOTES
IMPORTANT: After transit where the fridge has been on
its side or back, ensure that the fridge is in a level, upright
position for 12 hours to allow compressor fl uids to redistribute evenly before use.
• To allow the interior to cool down properly, run the fridge for at least
4 hours empty before adding food.
• This fridge is designed to operate on 12 or 24 volts DC ONLY.
DO NOT CONNECT THIS FRIDGE TO AN AC (alternating
current) POWER SOURCE UNLESS IT IS THE SUPPLIED
UNIQUE AC/DC PLUG.
• This fridge is designed for domestic use only! It is intended for the
storage of edible/consumable food and drinks. It is not intended for
commercial or industrial use.
• Never use excessive force on the handle to open the door.
• If the room/ambient temperature approaches the fridge’s operating
temperature, the fridge may not function correctly. If the room/
ambient temperature exceeds 100˚F (38˚C) the fridge may not
function correctly.
• A DC powered fridge has a lower cooling capacity than typical ACpowered appliances. Because the compressor is small, the fridge/
freezer runs more e ciently but lacks the ability to cool larger warm
loads as quickly as typical AC-powered appliances.
These warnings are provided in the interest of your safety. Please
ensure that you understand them all before installing or using this
fridge. Your safety is of paramount importance. If you are unsure about
any of these meanings or warnings, contact your local product dealer
or Unique Appliances for assistance.
PRIOR TO INSTALLATION:
At delivery, please check that the fridge is complete and has not been
damaged during transport. It is not advised to connect an appliance
that has been damaged, especially damage to the electrical supply
cable or refrigerant circuit. In the event of damage please contact your
local product dealer or Unique Appliances for assistance.
3
IMPORTANT SAFETY NOTES continued
GENERAL SAFETY
• Before cleaning or repositioning the fridge/freezer, always disconnect
from the electrical power supply.
• Service the fridge/freezer only if you are a trained or authorized
refrigeration technician.
• This appliance contains refrigerant R290 and a polymer compressor
oil in its refrigerant circuit. Take utmost care when handling your
fridge so as to not cause damage to the refrigerant circuit with
consequent possible leakage.
• Do not use other electrical appliances (such as ice cream makers)
inside of the refrigerating appliance.
CHILD SAFETY
• Do not allow children to play in, on or around the fridge. It is not a
toy. THERE IS A DANGER OF SUFFOCATION IF A CHILD BECOMES
TRAPPED INSIDE.
• When the appliance is not in use, secure or remove the doors to
prevent children from playing inside the cabinets.
• DANGER OF SUFFOCATION - Keep children away from all packaging
material.
INSTA L L ATION
• This appliance is heavy. Care should be taken when moving it.
• This appliance operates on 12 or 24 Volts DC (Direct Current) only!
• Under no circumstances should this appliance be directly connected
to an AC (Alternating Current) power source.
• Be sure that the appliance does not stand on the electrical supply
cable. Also, be sure the electrical cable is not squeezed or bent when
the appliance is being installed or moved.
• Installation work and adjustments on the appliance must be carried
out by qualified personnel only. Work performed by persons
with inadequate technical knowledge may adversely eect the
performance of the appliance, causing damage to the equipment, and
void the warranty.
• It is dangerous to make alterations or attempt to modify this product
in any way. Product alterations will void the warranty.
4
IMPORTANT SAFETY NOTES continued
DURING USE
• This appliance is designed for domestic use only, specifically for
the storage of food and drinks. This appliance is not designed for
commercial or industrial use.
• Do not store any containers with flammable vapors or liquids in or
around the appliance, such as organic solvents, spray cans, gas cans,
etc. Danger of explosion!
CLEANING
• Before cleaning always turn the fridge/freezer o and disconnect it
from the electrical power supply.
• Allow inside of fridge/freezer to fully thaw, then wash the inside and
outside of the appliance with lukewarm water and a mild soap or
detergent. Abrasive or corrosive cleaning agents, steel wool, scouring
sponges, or chemical cleaning agents should not be used under any
circumstances.
SERVICING
• This product should be serviced by an authorized technician and only
genuine spare parts should be used.
• Under no circumstances should you attempt to repair the appliance
yourself. Repairs carried out by inexperienced persons may cause
injury or serious malfunctioning of the appliance. Unauthorized work
may void the warranty.
DISPOSING OF THE APPLIANCE
• When disposing of your fridge, use an authorized disposal site.
The refrigerant must be completely drained and collected by an
authorized technician for recycling prior to disposal. Check with your
local Environmental Agency for recommendations on recycling this
appliance in your area. Remove the electrical connection wiring and
also ensure that the lid is removed to prevent children from being
trapped inside - DANGER OF SUFFOCATION!
5
PRODUCT FEATURES
6
PARTS LIST
2
7
3
4
1
1
1
9
11
11
12
8
13
10
10
10
5
10
10
10
1. Shelf
2. Freezer shelf
3. Light bulb with cover
4. Thermostat 0 - 6
5. Door
6. Upper hinge
7. Middle hinge
6
8. Lower hinge
9. Wire mesh basket
10. Detachable door rack
11. Adjustable feet
12. Egg trays
13. Ice tray
AC/DC Plug 110V
(optional for on-grid use)
available for purchase from
www.uniqueappliances.com
INSTALLATION
UNPACKING AND CLEANING
Remove all packaging and securing tapes from the appliance. To
avoid injury and causing damage to the appliance, be extremely
cautious when using sharp or pointed tools to complete this task.
Keep children away from the packaging material - DANGER OF
SUFFOCATION!. Wash the inside and outside of the appliance with
lukewarm water and a mild soap or detergent. Abrasive or corrosive
cleaning agents, steel wool, scouring sponges, or chemical cleaning
agents should not be used under any circumstances. A sponge, soft
brush or towel is recommended. After cleaning, thoroughly rinse and
dry. You may want to leave the doors open allowing the compartments
to ventilate for 20-30 minutes to get rid of residual odors. Check with
your local Environmental Agency for recommendations on recycling
packaging materials in your area.
POSITIONING THE APPLIANCE
The area in which the fridge is to be installed must be relatively cool,
dry, and suitably ventilated. The area must be protected against any
inclement weather (rain, snow) and excessive surface dust. To ensure
proper function, the appliance must be placed horizontally on a flat,
firm, and stable surface resting level on all four supports. The floor must
be strong enough to support a fully loaded cabinet. Use wood or metal
shims to level the fridge if necessary.
Do not place the fridge close to heat sources (heater, stove, boiler,
chimney, etc.), and avoid prolonged exposure to direct sunlight. This
appliance uses the exterior walls to transfer heat from the inside of the
cabinet. Ensure that there is adequate space between the fridge and
neighboring walls or large objects. A minimum spacing of 3” (7.5 cm)
is highly recommended. This will provide sucient airflow around the
appliance resulting in more ecient operation and longer appliance
lifetime. Always keep the air vent openings of the compressor housing
cover free from dust and obstructions.
7
INSTALLATION continued
DOOR REMOVAL AND REVERSAL INSTRUCTIONS
NOTE: The direction in which your refrigerator doors open (door swing)
can be reversed, from left to right or right to left, by moving the door
hinges from one side to the other. Reversing the door swing, should be
performed, by a qualified person.
1. Remove top hinge cover
2. Remove top hinge with Phillips screwdriver and lift freezer door o
of center hinge and set door aside.
3. Unscrew center hinge with Phillips screwdriver
4. Lift refrigerator door o of bottom hinge and set aside.
5. Remove bottom hinge with Phillips screwdriver.
6. Now remove all plugs and caps from opposite side and place them
in the holes you just remove the screws from.
7. Using a Phillips screwdriver fasten the bottom hinge in place using
the screws you previously removed.
8. Place fridge door on bottom hinge, then place middle hinge in top
hole of fridge door and using the Phillips screwdriver, fasten the
middle hinge in place using the screws you previously removed.
9. Now place the freezer door on top of the middle hinge, then
place top hinge in top hole of freezer door and using the Phillips
screwdriver, fasten the top hinge in place using the screws you
previously removed.
10. Tighten all screws while making adjustments where necessary
to ensure they are aligned correctly and closing well against the
cabinet, this will reduce any excessive frost build up
NOTE: Once the doors are reversed and if the gasket does not meet
the cabinet on the hinged side, using a hair dryer or heat gun heat
the gasket while on the appliance. The gasket will expand to meet
the cabinet. Allow 30 minutes to cool before opening
IMPORTANT: After transit where the fridge has been
on its side or back, ensure that the fridge is in a level,
upright position for 12 hours to allow compressor fluids to
redistribute evenly before use.
8
Loading...