Page 1
TOOLS REQUIRED
Phillips
screwdriver PencilLevel
Floating Shelf Installation
Power drill
5/16 in. drill bit
A B
C D E
PREPARING FOR INSTALLATION
1
While holding the backplate (B)
against the wall, use a level to ensure
that the backplate (B) is level.
Use a pencil to mark the backplate
(B) holes on the wall.
Ensure that arrow located on
backplate (B) is pointing up.
INSTALLING THE BACKPLATE
2
IMPORTANT : If you are drilling into
a stud, it is NOT necessary to pre-drill
！
the hole !
Using a power drill and a 5/16 in.
drill bit, drill holes into the wall at the
pencil marks.
Insert the drywall anchors (D) into the
holes and lightly tap anchors with a
hammer until they are securely in
place flush with the face of the wall.
Use a phillips screwdriver and the
screws (C)to secure the backplate
(B) to the wall.
B
length of shelf
16” - 48”
3 INSTALLING THE SHELF
Slide the shelf (A) onto the backplate (B).
Align the holes on the bottom of the
shelf (A) with the holes on the bottom
of the tubes on the backplate(B).
Use the set screws (E) to secure
the shelf (A) to the backplate (B) by
inserting the set screws(E) through
the bottom of the shelf (A) and into
the backplate tubes.
c
B
c
The number of mounting holes is more than that of screws，please install according to actual needs.
Pipe bracket has a built-in safety design feature. Pipes have a slight upward angle to prevent shelf board from drooping when shelf is
loaded. Weight ratings are for EDL (Evenly Distributed Load). Maximum load capacity is achieved by mounting screws into studs or
cement walls. NOTE: If mounting to gypsum rock (cavity wall), it is advised to mount screws into a stud or studs where possible. For
hollow wall mounting, you may use any of the holes in the backplate based on what is most suitable for your space. However, do not
leave either end of the backplate unsupported by at least one anchor.
16” - 48”
30 lb.
DISCLAIMER: Install shelf units according to instructions provided. We and our related companies are not responsible for injury
or damage resulting from incorrect installation or use. Welland products are for use only as wall-mounted shelves and are not
intended for any other purposes.
E
E
A B
Loading...