IMPORTANT RECOMMENDATIONS / RECOMENDACIONES IMPORTANTES
-The cabinet MUST be used exclusively indoors, do not expose to direct sun. / El mueble debe ser usado únicamente en
interiores, no exponer al sol directo.
-Do NOT overload the cabinet (see suggested loads), . / Do not hit or hammer the cabinet (just when indicated)NO
sobrecargar el mueble (ver las cargas sugeridas). No golpear ni martillar el mueble (solo cuando se indique).
-Do not drag, lift and move between two people. / No arrastre el mueble, levántelo entre dos personas.
-All timber surfaces will change color over time. New furniture will initially vary in shade from items that have been
previously purchased. / Toda superficie de madera cambia de color con el tiempo. Al principio, el tono de los muebles
nuevos puede variar al tono de los muebles que se compraron anteriormente.
-Spray polishes are best avoided as they contain silicones which may spoil the furniture's surface by building up over
time. Do not paint the cabinet. / Recomendamos evitar los pulidores en aerosol ya que contienen siliconas que, con el
tiempo, pueden deteriorar la supericie de los muebles. No pintar el mueble.
-Make sure all surfaces are protected from heat and liquids by mats and coasters. Wipe up spills immediately and ensure
that a mat or pad is placed under paper if you are writing. / Asegúrese de proteger las superficies del calor y los líquidos
utilizando esteras y posavasos. Limpie los derrames inmediatamente y, si va a escribir, asegúrese de colocar un tapete o
almohadilla debajo del papel.
-Our furniture will endure most temperatures in the home but it is best to avoid placing furniture next to heat sources such
as radiators or fires. Be particularly careful with solid wood as the lack of humidity caused by central heating can cause
damage such as warping. / Nuestros muebles pueden soportar la mayoría de las temperaturas en el hogar, pero
recomendamos evitar colocarlos cerca de fuentes de calor tales como radiadores o fuego. Tenga especial cuidado con la
madera maciza, ya que la falta de humedad ocasionada por la calefacción central puede causar daños, tales como la
deformación.
-Visible screws and bolts must be checked regularly and tightened (if necessary) shortly after purchase. / Luego de la
compra, revise regularmente los tornillos y los pernos visibles y ajústelos (de ser necesario).
-Felt knobs are recommended fitted underneath the legs or bases if the furniture is to be placed on a wooden or parquet
floor or surface. / Se recomienda instalar perillas de fieltro debajo de las patas o bases si los muebles se colocarán en un
piso o superficie de madera o parquet.
MAINTENANCE / MANTENIMIENTO
-When cleaning is needed, use a damp cloth followed by a dry cloth. Remove liquid spills immediately from the frame and
mechanism parts. Clean metallic hardware with a dry cloth. / Cuando se necesite limpiar, use un paño húmedo seguido
de un paño seco. Retire los derrames de líquidos inmediatamente de la estructura y las partes del mecanismo. Limpiar
los herrajes metálicos con un paño seco.
WARNING/
ADVERTENCIA
Page 2
Never allow children to climb or manipulate the cabinet, furniture tip over can cause serious
!
injuries or death. / Nunca permita que los niños escalen o manipulen el mueble, la caída de este
puede provocar lesiones graves o la muerte.
Page 3
INDEX
ÍNDICE
Assembly Hardware
Assembly Parts
Suggested Loads
Assembly Recommendations
Assembly Steps
Warranty
REQUIRED TOOLS*HERRAMIENTAS NECESARIAS*
4
5
6
6
7-10
11
Herrajes para Armado
Piezas de Armado
Cargas Sugeridas
Recomendaciones de Ensamble
Pasos de Armado
Garantía
4
5
6
6
7-10
11
*Not included, and not shown actual size.
Page 3
*5/32" wrench or adjustable
wrench.
*Llave boca fjja de 5/32" o
llave de boca ajustable
*No incluidas y no se muestran en tamaño real.
Page 4
ASSEMBLY HARDWAREHERRAJES PARA ARMADO
Please check that the hardware content is correct.
If any item is missing, please call to our customer
service line.
x16
1/2" Drywall Screw
Tornillo de
ensamble 1/2"
x16
Thread Screw
Tornillo redondo
de rosca
Compruebe que el contenido de los herrajes sea
el correcto. En caso de que falte alguna pieza, por
favor llame a nuestra línea de atención al cliente.
x1
Wall Fixing Kit
(Screws included)
Kit antivuelco
x16
Steel Nut
Tuerca
(4 Legs + 1 Frame with mesh + 1 simple Frame)
(4 patas + 1 Marco con Malla + 1 Marco sencillo)
Hardware items are NOT shown actual size.
Page 4
x1
Sideboard Metallic Kit
Kit metálico Recibidor
Los herrajes no se muestran en el tamaño real.
Page 5
ASSEMBLY PARTSPIEZAS DE ARMADO
A
Page 5
A - x1 Und / Unit
+
Sideboard Metallic Kit
Kit metálico Recibidor
Page 6
MAX SUGGESTED LOADS
CARGAS MÁXIMAS SUGERIDAS
11lb
11lb
ASSEMBLY
5Kg
5Kg
RECOMENDACIONES
RECOMMENDATIONS
Two people are recommended to assemble
the product.
Assemble the cabinet on a flat, smooth
surface, preferably on a carpeted floor
or the carton box of the product.
Carefully read the assembly instructions
and identify every wood and hardware
part before start assemblying the cabinet.
DE ENSAMBLE
Ensamble el mueble entre dos personas.
Ensamble el mueble sobre una superficie
plana y lisa, preferiblemente sobre un
tapete o el cartón de la caja
Lea cuidadosamente las instrucciones e
identifique todas las piezas y herrajes
antes de empezar a armar el mueble.
Page 6
Page 7
1
Install the metallic frames as shown below through the thread screws + Steel nuts.
Instale los marcos metálicos como se muestra a continuación mediante los tornillos de rosca + tuercas.
*Use 5/32" wrench or
adjustable wrench. /
*Use llave boca fjja de 5/32" o
llave de boca ajustable.
2
Thread Screw +
Steel Nut
Tornillo redondo de
rosca + Tuerca
Page 7
Page 8
3
Install the two remaining legs./ Instale las otras dos patas.
*Use 5/32" wrench or
adjustable wrench. /
*Use llave boca fjja de 5/32" o
llave de boca ajustable.
4
Thread Screw +
Be careful turning over the cabinet.
!
Tenga cuidado al voltear el mueble.
Install the remaining thread screws + Steel nuts.
/ Instale los demás tornillos de rosca + Tuercas.
Steel Nut
Tornillo redondo de
rosca + Tuerca
Page 8
Page 9
5
x16
1/2" Drywall
Screw
Tornillo de
Ensamble 1/2"
Install the “A” piece to the metallic kit
through the drywall screws. /
Instale la pieza “A” al kit metálico mediante
los tornillos de ensamble.
A
6
Be careful turning over the cabinet.
!
Verify that all nuts are tight to ensure the stability of the product. /
Verifique que todas las tuercas estén bien apretadas para garantizar la
Tenga cuidado al voltear el mueble.
estabilidad del producto.
A
Page 9
Page 10
7
!
For the user safety, it is recommended
to anchor the cabinet to the wall.
-WARNING! TIPPING HAZARD – Unanchored
furniture can tip over
-WARNING: CHECK FOR HIDDEN PIPES AND
CABLES BEFORE DRILLING.
-IMPORTANT: IF YOUR WALLS ARE NOT SOLID
LIKE BRICK OR STONE, YOU WILL REQUIRE
SPECIALIST FITTINGS (NOT SUPPLIED)
-Pre-drill small pilot hole on the back edge of the
furniture top using a 2mm drill bit. Attach the other
end of the fixing strip to the back edge of the furniture
top using the 15mm screw + washer and securely
tighten.
-Place fixing strip against the wall and mark position
for drilling hole.
-Drill hole in your wall to a depth of 30mm using a
6mm drill bit. If the surface of your wall is soft and
crumbly, we would advise you to use a 5mm drill bit
for a tighter fit.
-Insert plug into hole with end flush to the wall
surface.
-Attach fixing strip to the wall using the 25mm screw
+ washer and securely tighten.
-¡ADVERTENCIA! PELIGRO DE VOLCAMIENTO Los muebles no anclados a la pared pueden
volcarse.
-¡ADVERTENCIA! Compruebe que no haya tubos
o cables ocultos antes de perforar la pared.
-¡ADVERTENCIA!: Si sus paredes no son sólidas
como ladrillo o concreto, necesitará anclaje
especial ( no suministrado).
Por la seguridad del usuario se recomienda
anclar el mueble a la pared.
-Pre-taladre un pequeño orificio piloto en el borde
posterior de la parte superior del mueble con una
broca de 2mm. Fije el otro extremo de la tira de
fijación al borde posterior del mueble con el tornillo
de 15mm + arandela y apriete firmemente.
-Coloque la tira de fijación contra la pared y marque
la posición para perforar.
Haga un agujero en la pared a una profundidad de
30mm con una broca de 6mm. Si la superficie de su
pared es suave y desmoronadiza, le recomendamos
que use una broca de 5mm para un ajuste más
apretado.
-Inserte el chazo plástico en el orificio con el extremo
al ras de la superficie de la pared.
-Fije la tira de fijación a la pared con el tornillo de
25mm + arandela y apriete firmemente.
A
After you finish assembling the
cabinet, take off the adhesive
letters.
Al terminar de armar, desprenda
las letras adhesivas.
Page 10
Page 11
WARRANTY POLICY
PÓLIZA DE GARANTÍA
We are committed to your satisfaction by offering you a competitive warranty to ensure all
our products are free from defects, in material and workmanship, to the original purchaser
for a period of one year from the date of your purchase.
How It Works
We are happy to furnish a replacement at no cost to you in the case we determine a
component to be defective. While our warranty applies to conditions of normal use,
it does not apply to defects or damage resulting from intentional or accidental damage,
outdoor use, negligence, or unreasonable use.
Page 11
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.