Page 1
Swing A-Frame
Tools Required:
You will need a #2 Philips or Robertson screwdriver and a ½ inch wrench/socket. (Assembly requires 2 people)
NOTE: Prior to starting – find pre-drilled holes in Top Beam (B) and attach 2 J-bolts, 2 washers and lock nuts.
IMPORTANT: After hanging swing, FULLY TIGHTEN Lock nuts on J-Bolts
Package Contents
(A) Legs… 4
(B) Header… 1
(C) Back Support… 1
(D) Corner Brace… 6
(E) Header Support… 2
(F) Side Brace… 2
Hardware:
• 2-1/2” screw… 44
• 4” Screw … 8
• J-Bolt… 2
• Washer… 2
• Lock Nut… 2
:
Step 1: Build Frame Sides
• Position two legs (A) so top is approx. 7 ¼” apart, and bottom is 48” apart.
• Set side braces (F) to span bottom of legs.
• Flush ends of side brace with bottom/side of legs – attach with 2 ½” screws.
• Repeat for other frame side.
Step 2: Attach Header
• Insert Header (B) between top of legs - allow ends of header to overhang side
of leg by 1 ½ inches on each end. – make flush with top of legs.
• Set header support (E) beneath header - attach to legs using 2 ½”
screws.
• Now attach legs to side of header using 4" square drive screws.
Step 3: Attach Back Support
• Place back support at bottom behind legs to span ends of side braces
• Flush ends with bottom side supports attach using 2 ½” screws.
Step 4: Attach Corner Braces
(attach to all 4 top corners + 2 lower leg corners)
• Position corner brace with one end centered on inside leg while other end is flush with top side of header.
• Connect using 2 ½” screws. Note: there will be a gap alongside of header/corner brace - this is normal).
• For lower leg attachment – set corner brace on inside of lower back leg and attach to back support.
• Your new a-frame is now ready for a swing.
♥
Thank you for choosing us
♥
Loading...