Uninet iColor Series User Manual

UniNet 3232 W. El Segundo Blvd., Hawthorne, California 90250 | [e-mail]

www.icolorprint.com

















iColor®Matrix Remover and Slitter

User Manual

IMPORTANT NOTICE

THE MACHINE CAN ALSO BE USED AS
SLITTER ONLY.

WHEN YOU DO THA T, PLEASE REMOVE
THE TOP MOTORIZED CORE HOLDER
AND ADJUST THE CLUTCH KNOB ON
THE UNWINDER CORE HOLDER.

CORE HOLDER

Non-Motorized core holder

Use only on

unwinder station

Motorized core holder

Waste Matrix
Take up mandrel / Weeder
(Motorized)

Take up mandrel
(Motorized)

Legend
MCH: MOTORIZED CORE HOLDER

Slitter
Blade Housing

Slitter station

Tension arm

Commands
Unwinder
Supply mandrel
(Non-Motorized)

Load the printed and die cut roll on
the supply mandrel (non-motorized).

Push until it touches roll guide.

1

RUN A JOB

WARNING: Before starting a new job, always make sure the

waste matrix from the previous job has been removed.
Do not attach the matrix from a different size label to an existing

roll.
This will cause an uneven wrap which will cause the material

to walk.

Note on Media Environment:

50% humidity and 72 degrees Fahrenheit is the optimal conditions for both storage and
use of label stock. Store label stock in protective plastic wrappings. Rewrap partially

used stock. Do not store stock directly on concrete oors.

Label stock should be conditioned in this environment for 72 hours prior to use. Failure
to store media in these conditions may result in media tension problems. Too much
humidity will cause labels to curl on the edges.

Place an empty wide core on the
mandrel (motorized).

Push the core until it touches the
core stop. Tighten using the tension
knob.

Insert the empty cardboard core on
the MCH (motorized) to receive the
new labels roll.

Set the supply mandrel in the supply
location. Match the gray handle to
gray holder.

3

4

2

Pull the printed labels for about fty

centimeters.

Set the weeder mandrel in the
weeder location on the top of the
MCH.

6

7

5

Paper path.