UniKeyboard DIVERGE 3 R0 ALEXANDRI, Diverge typeZERO R0 Alexandri Magni Assembly Instructions Manual
DIVERGE 3 R0 “ALEXANDRI”
SPLIT ERGONOMIC MECHANICAL BACKLID KEYBOARD
Model: Diverge typeZERO R0 “Alexandri Magni”
Dimensions: 180mm x 170mm x 20mm per side
Number of Keys: 72
Max Number of Layers: 8
Keycaps: 1u x 72
Interface: HID via USB
Rollover: NKRO/6KRO Togglable
Assembly Instruction: http://unikeyboard.io/instruct/diverge-3
01
- Choking Hazard:
This product contains small parts, use with adult supervision.
- Lead Hazard:
The solder used on the PCB contains lead which may lead to lead
poisoning, the solder that you are using also very likely contains lead
if it is not explicitly labelled as “Lead Free,” do not eat or drink whilst
soldering and do not bite your fingers, solder wire, or soldering iron.
- Temperature Hazard:
Assembly of this kit requires the use of a soldering iron, a soldering iron
is extremely hot when turned on, do not touch, or lick any parts of a
soldering iron which is hot with any of your body parts other than the
handle with your hand.
WARNING
PARTS
Acrylic Frames (Two of each)
PCB x 2 Pro Micro x 2
Diodes x 72
Switches x 72
MOSFET x 2
Resistor x 2
(100Kohm)
Resistors x 73
(100ohm)
LEDs x 72
USB Cable x 1
Ziptie x 1
TRRS Cable x 1
TRRS Socket x 2
02
ASSEMBLY INSTRUCTIONS
01
Bend all diodes as shown below
02
Orient the PCB as follows
Make sure to orient all
the diodes like this
03
We are now assembling the LEFT side, insert all the diodes as shown below
Now solder on all the diodes
04
Reorient your PCB as follows
05
Cut off the leads with a nail clipper
or snipper
06
Reorient your PCB as follows
03
07
Solder on the MOSFET, notice the
orientation of the MOSFET marked by
a dot in the corner, solder the marked
resistors if you wish to install LEDs
100ohm 100kohm
08
Solder on the resistors on all the
switches (skip this step if you do not
need LEDs)
10
Reorient your PCB as follows
12
(Optional) Place sellotape onto the
location marked with a red rectangle
13
Orient the LEFT controller as follows
(Controller package should be marked
LEFT or RIGHT)
14
Place and solder the controller
as follows
09
Insert 2 leads cut from the diodes and
solder them by following the white
lines on the PCB
11
Solder on the TRRS jack, make sure
the TRRS jack is facing up and the
diodes are facing down
Loading...